Search results

  1. M

    Removing Heat Pump - Bosch

    I have a Bosch sms63m22gb dishwasher. The heatpump has fried so I am trying to get access to it by removing the side panel. I don't know how to safely remove the control board to get access inside. There's hardly any room Any ideas? Thanks
  2. M

    Extractor fan ducting fell down. How to reach

    Possibly a silly question but how do most people reach high points in the loft. My extractor fan ducting has fallen from where the vent is on the roof. Will get ducting but need to reach out safely. My loft isn't boarded just your standard 40/60 cm joints apart
  3. M

    Heating downstairs only works if upstairs is called.

    I've got 2 thermostats, upstairs and downstairs. Downstairs thermostat was calling for heat but boiler did not react. Then I called for upstairs and boiler got the signal and the rads upstairs started heating (downstairs not calling for heat). Swapped the thermostats, issue remained (so...
  4. M

    Repairing hairline crack on casting for a pressure washer

    Hi, I have a electric pressure washer (Vax). I have a crack asking the outlet thread. I don't want to throw it all away. Is there someway I could repair this it's had very minimal use. Thanks
  5. M

    Trivial tee valve

    I think I'm missing the trick here. I want to convert this into an outlet that I can connect a hose to as well as the toilet cistern. I'm sure I need a tee valve but they all seem to be either 2 compression ends 1 screw on with a single lever. I want to be able to turn the hose off as well and...
  6. M

    Replace existing thermostat with WiFi version

    I'm planning on replacing my existing danfoss tp4/5000 with one of the numerous WiFi thermostats available from China. There are a few different designs but the contacts are more or less the same. Just want to clarify the following will work. Attached is a picture of my current thermostat with...
  7. M

    Install Nest over Potterton EP2002 Y-Plan

    So there I was I planned everything in advanced for my father's home. He sent me all the details of our current boiler and heating system and I was convinced that it was a y plan system because i have a 3 port valve that says "y plan". I arrive to do the job and I see this silly wire set up. Why...
  8. M

    Replace Danfoss Tp4000

    Hi, I have two danfoss tp4000 in my house. I want to replace these with smarter versions of it. Preferably something where I can just replace the thermostat and make it all smart with the ability to control it remotely. I have combi boiler so i think investing in a nest and or hive/tado is...
Back
Top