Search results

adjusted the cam on the rollers and it didn't help much. moved the keeps up about 5mm and it's now pulling in tight, no drafts!

can I move the keep closer to the roller? in the looked position, probably only half the roller is in the keep. I'm thinking it should be more?

I've not tried adjusting the rollers yet because they are only just engaging the keep and then I saw that the keeps didn't seem to sit flat.

Sorry, yes, French doors.

Just moved into a property with a upvc French door. Locking it last night I noticed a right draft coming in above and below the handle where it's not quite closing tight. Had a look at the roller keeps and they don't look like they are the right ones. Anybody know which ones should be...

The other thermostat is at the back of the oven. This is just going off the diagram i have found of the oven parts. There is also a thermostat sensor in the side of the oven. On the part list it show the thermostat next to the cooling fan has a value of 80 degrees C, and the one at the back is...

Hi. Just moved into a house that has a Cata Modus built in oven. We used it, then turned it off and after probably 10 minutes later, it trips at the fuse box. I noticed the control panel and front glass was hot, so checked the cooling fan was working. It is, and does its job whilst the...

right. sorted. Nothing has changed. But when I just tried it, it accepted the code and flashed up all the zone errors and tamper fault. Put code in again and it silenced it. Seems to be setting ok, so I'll see how we get on! Cheers for the help!

Right. I have no spare wires to the keypad. I do have a meter.

will look tomorrow. Gave up in favour of beer and curry! Thanks for peoples help so far!

As soon as I pull the battery connector, both sirens stop instantly. I'll have to strip the heat shrink on the repair and see. It was only cut in one place and work fine before.

I'll see if I can get me dad round tomorrow to watch the keypad.

just tried again, still no joy. Both sirens are going. Power to the keypad, but none of the LED's are lit next to any of the errors or zones. Tried our old code, 1234, and 0000, none of them turn it off. So pulled the plug on the battery again.

Ha! I was getting a little ahead of myself and forgot I hadn't re-attached the sensor where I had been decorating. Thats where the short was. Put that on, and now got power back to everything. When I plug the battery in, both the external and internal alarms are sounding. Putting the code...

Hi. Only just got around to trying the new fuses. I disconnected from the mains, and replaced the fuse that had blown. But, as soon as I put it in, it blew. I disconnected the large battery that is on the main board, put in another fuse. As soon as I reconnect the battery, the fuse blows again...

Thanks for that. I'll have a look when I finish work tomorrow.

Scantronic 9449 with 9427 keypad Cutting some carpet back a few weeks ago, I caught the alarm cable that goes from the keypad to the main box in the garage. I'd cut through the red & black wires, causing the keypad to lose power and the small speaker in the lounge to go off. Disconnected the...

Hi, I’ve recently bought a house with a alarm, but no paper work or anything. All we know is the code. I’m trying to find a manual or something so that I can change the code and put it in service mode or something . I’m having a upvc front door put in so want to change the sensor in the wooden...

The bit i marked as 'pivot' seems to have had a metal band/washer around it and made it wider. We found it on the floor looks worn and broken. Without it, the bracket with the pin on is further away from the frame and is now hitting the top of the locator. I suppose the only way to fix it is to...