Search results

cheers peter it was just slightly below min

Cheers for the quick replies, The oil level shows max but oil warning light still on.I have'nt drove it far today about 10miles.i hope its the switch :cry:

Hi all, Ive got a ford transit 85 T280 SWB.The other day the oil light came on,i checked oil which was very low,topped up with new,and light went off.Now oil light back on and stays on :cry:please help! ps there does'nt seem to be any leaks

thanks for the reply and yes it is 800l version

just moved to our new house and previous owners didnt leave any paperwork for the alarm.At the moment its not activated but i need the engineers code to rest system and program our new code.Any ideas?

im looking to buy a new property ive viewed,but buying depends on whether i can build a small single extension on the side of the property. The property is a linked detached(linked by garage to neighbours house),what i would like to do is remove the garage and add an extension for...

excellent many thanks :D

yes sir re its like a megaflo,thanks for the reply

ive just wired a s plan system using existing cylinder. On the cylinder there is a 3 core coming from the stat which ive wired back to the jb,but also there is a 3c (L,SWL,E) coming from a thermal cut out device which is also attached to the cylinder.can any of you tell me where this should be...

they look like the old mk type

can any of you tell me what wholesaler stock siemen mcb's,or what other make fits

silly question i know,but are you screwing back switch plate when reseting mcb.cos 1 of the cables might be tight against the back box and causing a live to earth fault which you are getting(no rubber gromet)

if there is only 1 sw in room turning on 4 wall lights,you should have what we call 2core and earth at the switch(1 feed,1 sw wire),for some reason you have 3 core and earth.which is why i say 1 core maybe a neutral.Try connecting red cable to com,yellow to L1 and blue in connector.

maybe 1 cable is a neutral

im installing 3 new circuits back to ex c/u,and upgrading gas and water for new extension.Anyway the builder has taken down a ceiling in the house and exposed a lot of live rubber cables doing exsisting lighting,any advice on how to tell owners that this is not good enough let alone not...

sorry no pics,im back on the job weds,ill see if i can get any more details.cheers

IM DOING 4 NEW CIRCUITS IN A HOUSE AND THERES 4 SPARE WAYS IN CU.THE ONLY PROBLEM IS THAT THE CU IS MADE BY DETA OF WHICH IVE NEVER COME ACROSS.COULD ANYBODY TELL ME WHERE I CAN GET THESE MCB'S FROM,OR IS THERE AN MCB THAT WILL FIT.

hi all i hope someone can help.My worcester 35cdi does not heat water very well,its just luke warm,but when i run cold tap the temp then rises but doesnt stay hot. ps 3 filthy kids (one 4 weeks old),HELP PLEASE

i need to run 35 mm tails from meter box to new consumer unit which is now going in the garage(pme).Its about 8m away and the only route available is through the first floor joists down a new pitched roof (inside :roll:)and then down to the meter box.Now the easiest way would be down the cavity...

just remember whats on your trolley of materials their there for a reason,just take a few minutes to read through job sheet and take your time.when it comes to motor circuit c/w stop start,wire one cable at a time via wiring diag its alot easier to understand. good luck