Search results

We're the waters come through the roof the ceilings plaster board has dropped out and fortunately the joists look ok from what I can inspect.

Thanks

Im 50 and an electrician. Also I've put a couple of flat roofs on garages 15 years ago, just need some advise from someone with knoledge.

My wife has very kindly volunteered me to replace my mother in laws flat roof. Last year one of her neighbours was doing some painting outside and it appears he damaged the roof (which I'm guessing was already rotten). So my plan is to remove the existing felt and ply and replace in reverse...

The above comments are correct all i can add is as an electrician who works on a lot of appliances it is often worth stripping the core back to the copper and the bend it back on itself so that it fully fills the terminal this way your sure of a tight connection.

Thank you both for the replies, the room is shut off from the rest of the house at present but we were hoping to open it up to the kitchen and use it as a dinning room in the winter. From what i remember the floor is insulated but i was planning on installing some underfloor heating the type...

Hi everyone ive had a conservatory for 10 years but like a lot of people its to hot in the summer and to cold in the winter, so im planning on insulating it on the inside. My plan is to use seletex between the perspex roof and the perspex roof supports. then to use batterning across the roof...

I have 240v power to the controls interface board could this stop the display working.ive disconnected the thermostat supply and then bridged out the no volt contacts but nothing happens still.

Thanks will follow your advise

You can change the socket legally under part p and can also cheaply buy a martindale plug in tested that will check alls ok for you.

no power to display board but there is to the main board could anything else create this problem without blowing the control fuse.

stuck last years card details on will submit correct card details

Does anyone know if there is a faulty output from the board ie fan motor could this stop the board giving a signal to tge lighting display or would it error code/ take out the control fuse. Am in tge process of waiting for combustion chamber approvement but am looking at the boiler sunday. thanks

How will i know when my details have been successfull. I put the card details in tuesday and wanted to post a boiler question before i take a look at a potterton on sunday. thanks

ok ive just put my details back in to ccs been told it could be an output but surely this would bring up an error code or take a fuse out.

Hi im going to look at the above boiler on sunday. the boiler has power to it and the control fuse is ok. The problem is the boiler is dead no lights or display any ideas would be a great help. im looking at the wiring diagram and fault chart and to me its saying pcb. i am gas safe and...

the full model is Main combi eco 25 made by baxi and ive checked through all the components including stripping the 3 way valve and re-greasing still have the same problem. so i guess it must be the board

Its a baxi eco 25 are you familia with this model and does it sound like a pcb to you

Sorry i dont understand the question what gas settings are set on the board ive been led to believe the error code is a comunication problem between the components and the board, regards jim

Ive been told on another forum this is a common fault caused by a failure on the pcb does this seem likely, as i will go and get one therwise, thanks jim