Search results

I'd love to help but am amazed that the responses just go on..and on...and on. Lime you say...too much theory.

Actually no. They paid me for one job but since then there has been nothing. Everything was covered by emails (costs before buying parts plus labour). They gave the go ahead. So with that in mind I felt covered legally and I think I am. it's just the boll**k ache chasing around. I clearly won't...

I was recently contacted by Boiler Cover UK (via GSR) and was asked if I would like to undertake occasional work for them. The staff were and still are personable so no problems there. To cut a long story short they owe me in the region of £900. To date I've had £115. I was informed that payment...

You have to keep the prv open whilst you pump this up

Thanks for the heads up on where to get the manual. The basics barring the gas rate were done baz, I do do the basics a blocked filter where ever will give such a problem. The tap is not the issue, like I said the cold to that tap was ..isolated...

Tony please mate, i can't find the bleeding place so ease up, no one should be bawled out in public...I'll find it thanx

Chantelle, as I've already mentioned, the cw to the bath was isolated so it can't be drawing through there. As I've already mentioned ...again...I'm GSR and once again...there is no manual. That's why I'm here, in case one of my peers can Assist me, as most of us have over the years in here.

Thanks Baz, I haven't gas rated it but I did increase B.P. as it was about 4mb. The problem only seems to be with the bath mate. the dhw pipe just goes very cool

I'm Gas Safe Registered. Been to a Heatline C24 to investigate Luke warm DHW. It seems ok at the sinks (kitchen and bathroom), but from the bath the DHW pipe at the CHB goes very cool indeed. I've isolated the Bath Cold water but the same thing occurred so I'm presuming the mixer is ok...

Well technically Gasright may have a point, however it's not what you say it's how you say it. That said I'd wager Mattensteins diagnosis is right. I left BG last year (phew!). There has been a constant issue from engineers about installs. One bloke can't powerflush a system and fit a boiler in...

Are you anywhere near Plymouth?

Absolutely nothing to do with a gasket. The expansion vessel requires air to be pumped into it. Half the time and cost of a gasket set. It seems the incompetents are taking you for a ride mate.

The landlord is responsible legally, you have the best intentions there's no way on this earth you would pay. Tell him / her to take you to court...they won't. If he starts bullying you then take him to court

Tony, it's the pump flow switch

yep, disconnected lead,tried that but it doesn't respond to adjustment (perhaps my answer is there).

Took alook at a Ferroli Modena 102 which kept cycling. Both sensors were around 15k (ohms) after some use so expected them to be lower. I also discovered that on both heat and DHW there was no modulation. Got the sensors and replaced but [no] surprise same issue. I can't decide on whether it's...

Thank you mate. Already been back and changed for another model. having a SMEG, to a Gas man it's all Greek, dunno if thats good or bad

Hi. Recently had this replacement appliance from Currys. The first one was doing exactly the same thing. 1) Absolutely goes berserk on the spin, so much so I turned it off for fear of destroying my new Kitchen. Doing the wash is ok (until the spin). 2) Doing the drying cycle gives us the...

thats how it is

started from zero 2 months ago...absolutely no clients as I never did private jobs. Had magnetic cards made on vistaprint, knocked doors and pitched my story about starting up and would they keep the card. Had quite a bit but not as much as I'd like. That said been out to a breakdown this...