Search results

tried turning it off for 24 hours but after turning back on it was o.k for about 10 hours then started freezing up again on the thermostat housing and on inner rear wall of fridge to the left of the housing.would that make it a problem with the thermostat or is what i am calling the thermostat...

my zanussi model zfk61/27ral is forming a large ice chunk on the inner rear wall of the fridge. i am told it is the compressor unit. could anyone help me by confirming this and if this is the fault tell me is it an easy job to carry out the repair thanks to all jimcas

it looks easy repair to do.the trim may be screwed on if not work round trim edge carefully with screwdriver to release buttons that hold it on.get a piece of wood on inside of door directly on the small crease and push it out gently by hand it should pop it and leave just the little crease...

thanks rocks for the quick reply its the removable back with bolt on spider and the drum a toughened plastic

Have outside toilet which is unused and have found a water leak in the cystern refill pipe below stop tap cannot find a mains stop cock so unable to turn of water supply, is there any way of capping or fitting a compression joint with the water running or anyone advise on other methods many...

have got bearing noise when machine is on spin cycle. can there be any way to grease it or if it needs replacing can anyone give me information on how to do it cheers jimcas

most fords around that period were known for damp.had same problem. remove door trim on drivers door dry contacts and switches down outer edge of door then spray with wd40 that should cure it

not been looking in the street just around the back yard to try finding it but you are on right lines cheers Jim

have an outside toilet that has not been used for years. pipework is leaking slowly at the shut off tap.can not find any mains water cut off outside to shut the water off anybody got any ideas thanks Jim

the bolt on the outside edge is most likely to be holding the window channel in place As for the trim removal take plastic cover from door release catch inside car and remove any fastening screws then remove 2 or maybe 3 plastic gromets from door armrest to access the screws and check for screws...

is there anyway that i can upload photos from a samsung steel mobile phone to my picture folder on my computer have tried with connection lead but not having any luck

You should have tried a cheese wire or similar tool like they use to remove windscreens to break the seal on the old wings. They are usually fixed on with body caulking which comes in strips like plasticine and that is the best thing to use Lay it between the inner and outer wings and you have...

In that case you wont need to prime them just give them good flatting with 800 grit wet &dry followed by flatting with 1200 grit then paint them Good luck jimcas

Are the parts already primed as some come that way? If not it would be advisable to apply a plastic adhesion primer which also stops paint cracking on flexible plastics. Available at any motor factors or paint stockists

when cold will not change out of 1st gear unless put in manual mode then after 4 or 5 miles when warmed up goes through all gears normally in any mode one repairer tells me it is pressure regulator another tells me it is fluid pressure valve. is there a difference and can anyone advise me on the...

machine would not complete wash cycle and water would not heat up the code was 3 flashes have fitted new heater element and now water is heating but dial is just going round and water seems to be on constant drain mode also am still getting 3 flashes for code would appreciate any help with this

kids decided to polish the screen with furniture polish now have large circles all over screen would appreciate any ideas on anything that might remove them

fridge icing up on back wall could this be thermostat problem? and are they easy to repair/replace thanks

When cold will not change up from 1st gear in drive mode but will will change up in manual mode.After about 4miles flick switch into drive mode and everything is normal Have changed fluid and filter checked all linkages but no different any help appreciated