Search results

had a problem with pressure fluctuation,with advice found to be exp vessel failure,got one on order with a new prv also. My q is what may have caused said failure,also i noticed the filling loop is on the flow side of circuit not the return.Will this affect performance.boiler is baxi 133he...

i have a old cast bath been reenamaled,changing the taps i have square holes inthe bath.the new taps are round3\4.flexi tap connectors fitted.the taps are not quite covering the ols square holes,therefore can drip below the bath.any help sorting this would be appreciated.thanks.

can i fit a 45a cooker switch in what was the airing cupboard to isolate the shower the other side of the airing cupboard wall.ie in the bathroom.although the airing cupboard is in the bathroom.is the cupboard in the bathroom.classed as the bathroom area.

can i put a washing machine in my bathroom.

could anyone tell me why my radiator literally burst when i put the heating on.just replaced a old rad for a new one upstairs.slightly bigger.primed it bled it topped the combi up to approx 1 bar.i did turn the wall thermostat to max to test the system.within 2 minutes heard two loud bangs from...

got a thermostatic mixer valve..combi boiler,just not getting hot enough.hot water elsewhere is fine possible causes please.thanks

i have a vectra 1800 2000 plate,the drivers door window has come out of its guides/runners.can anyone please tell me the best way to get it all back in sync.thanks in anticipation.

can i change my existing light in the kitchen for 5 or 6 50w down lighters all wired from a hd jbox ie 1 cable for each fitting.would this have to be part p approved or is it non notifiable.thanks in anticipation.

could someone please tell me where the central locking relay is located on a vaux vectra 1.8 petrol. on a 2000 plate.and which 1 it is.when activated with key fob,lights flash but relays do not engage.thanks

could anyone advise me the best way to keep an eye on my car.in a 4 storie block of flats.cctv would be attacked by the local yobs.video or the like from inside the flat is where im looking at.can anyone advise of a suitable system...with thanks.

baxi solo2 50pf.boiler start up ok fan runs but no spark to ignition.suspect faulty air pressure switch..any way i can check it to make sure.

i have a baxi 133 he,had some work done recentlyboiler had to be taken off the wall,secured then put back.on refitting the lead to the gas valve was inadvertantly disconnected,the system would then not fire up,on noticing the connector plug was not located properly.proceeded to plug it back in...

i would like to alter 2 4ft wide windows, and replace with 4ft french doors opening inwards with juliet balconys on outside wall.i am in a council flat 1st floor in a block of 3 floors.i would love a balcony to be able to sit on,if that is possible.please point me in the right direction initally...

i need a new supply to gas hob.can i put a pipe in the floor.concrete.

recently had new rads fitted,all balanced working ok.call for hot water and boiler stops.it will give hot water,but wont go back to heating.have to switch off and on to reset.then a call for hot water have to reset again and so on.boiler is a gloworm xtrafast.any possible causes remedys.thanks...

Help needed,rads not getting hot upstairs.tied to bleed..no pressure.up the loft to check header tank...no header.checked the cold water tank.the filling pipe is way above the water level.about 20mm below the incoming valve.suggestions please.the system is a old back boiler/gas fire.thanks in...