Search results

drained a little water form rad via the bleed valve and its clean do i need to test form anywhere else

yeah i could what they best way through the bleed valve

out rads are not getting hot they are just warm all rads in the house are the same and are warm all over not just at the top/bottom. i cannot sem to work out why tihs would be i have bled them all made sure the bioler is a at pressure by re filling and also re charging the expansion...

right seems like i fixed it i got this guide to re charging the expansion vessel //www.diynot.com/forums/viewtopic.php?t=37170 went and bought a pump with a gauge and the pressure is now just over a 1bar when not in use and just over 2 when on. so it looks like the vessel did...

its right up on the boiler we dont have a separate thermastat

there is just one knob and water is coming through its not got much pressure to the water though doesnt blast out i know this as i turned the knob with the loop off to make sure it was working. so what about the expansion vessel easy to refill??

i dont think there is any dripping i will chack if there is whats the issue?? also how do you charge the vessel is it a plumbers job or can it be diy

i have a baxi he80 when the boiler is off its sits below .5 bar. hot water and heating do work and when switched on the pressure rises to about 1.5 bar. i have tried repressuring using the filling loop but its dosent seem to have any effect on it at all just stays below a bar never...

nice thread just a quick as i now have this issue do you need to turn the house water off or just isolate the mains form the boiler with the cold water inlet valve and which tap under the boiler is the cold water inlet as there are 3 taps which can be turned

hi here are a few pics its leaking from where the valve meets the swith you can see the water marks on the parts and one from underneath thanks

we had a guy out for a dirrent fault who mentioned that the o ringg would need replaceing in the assembly if it leaked as it has previouly leaked from there but then stopped is this the correct part http://www.sparestraders.co.uk/product/baxi-248065-diaphragm-3-way-valve/

the leak is coming from the 3 way valve assembly i have heard the is a service kit for this but cannot find any part numbers can any one help also is it an easy job to take on yourself

i have now had a plumber out and it was deffinatly the pcb working fine now a new one has been fitted

whats the best way to check the APS? i am not going to just buy on a whim but i think its likly to be that. seems as though many poeple habe had a new APS fitted and still doesnt fix the issue

i have done a fair bit of reading on this now and seems that its going to be most likly the pcb does any one have the part numbers for a replacement

the fan seems to spin freely if you do it by hand seems like no power or not triggering for some reason

hi everyone my boiler today has the fan/flu light flashing i have done the reset and had a look at the pcb it looks to be fine and clean the fan does not seem to spin. should it if the heating is set to constent?? even though its showing a fault anyone got any ideas of what it...