Search results

Just a quick follow up to this. I ended up contacting Triton who advised that they can arrange an engineer to be called out. As mentioned they told me that if the fault was not a product fault it would cost £85, otherwise no charge. The engineer visted and replaced the slide valve and the...

Hi, I've just purchased and installed a Triton Elina concentric shower mixer valve. It is to replace another shower mixer valve that is knackered. I took quite a long time installing it and it all seemed to be fine but I noticed some droplets of water on the bulkhead overnight. It appears...

No problem, I'm very grateful for your suggestions in any case. I believe that the centre valve is for temperature as the smaller lever has a series of dots on it and ends up with the number 38C on it. The splines on that are fine and that part is easy enough to turn even without the lever on...

Thanks for the reply. I can't seem to find any obvious isolators unfortunately. I guess I can turn the main water supply stop off. Would any of the suggestions you've made about capping off the inlets or rigid riser cause the flow controller to not be able to seemingly bite into and turn the...

Hi, I've just moved into a new house and the previous owner mentioned that the concentric mixer shower has been disabled since there's an electric shower in the cubicle as well. Supposedly, the mixer shower still works - just that it's been disabled since it's not recommended to use both shower...

Ok. As a follow up, I've done as instructed in the FAQ, and it's been over 3 hours now. The house is now quite hot due to the central heatig being on. However, there's still no hot water whatsoever - not even warm. In the cylinder cupboard, I've felt the pipes, the pipe above the valve that...

Hmm.. I'm sure I did do that over the past day. All that seemed to happen was that the central heating got very hot - but no hot water at all. I felt the pipes separated by the valve and the top whilst hot, the bottom was stone cold. This is after the valve was manually opened of course. It...

Ok. I've read through the faq again - I've got the opposite problem, how would I adjust the stat settings for hot water only? I don't need the heating on in this weather? Obviously, I'd have to turn Central Heating on at the programmer... would I have to adjust the central heating thermostat...

I've got no hot water working...but the central heating works. Can anyone post any advice on what to do about this? I've followed the FAQ about manually opening up the valve and turning the heating on. For some reason, no (hot) water seems to be going through the (now manually opened) valve...

No it doesn't seem to go to fault. I've tried to hold to reset but it seems to do nothing.

It turns on/off - by that I mean that through the pilot light hole, you can see the gas burners coming on. It clicks a few times, then ignites and then after about 2 seconds extinguishes. Cycle repeats over and over. This is when I try run the hot tap.

Hi, I have a problem with the boiler. It's coming on but won't stay on. It extinguishes after about 2 seconds and continues to do this over and over. I took the cover off and after some reading around, some mentioned it might be the microswitch. I looked at it and noticed that the pin was...