Search results

I eventually managed to get a service engineer out and he confirmed the 30c on the 60c cotton prog. He ordered a new board and heater element. Fitted the heater element but the board was the wrong part. Put the old board back in so same as before and as expected the new heater didnt make any...

Thanks for your reply. I have since done another wash at 60c and then when the heater has cut out drained enough water out so that I can open the door. I then used my digital thermometer which has a waterproof probe and placed it in the water. It measured 30c. I thought this would be a more...

I have had this Beko WTL82051 machine for about 3 months. The problem is that it doesn't get hot enough on the 60deg programme. From new I have noticed that on the 60deg cotton programme after the heater has cut out by monitoring the wattage on my smart electric meter and placing the palm of...

Thanks for your reply. I will try that

I had this oil boiler fitted last year and on returning from a holiday switching on the central heating for the first time over the summer last week I noticed one of the radiators needed bleeding. I bled it but being very tired I didn't tighten the bleed valve sufficiently and some water leaked...

I didn't actually need to reset a thermostat I managed to just reset with the control panel.

OK Ive got it going again thanks for your help

Thanks for your reply Can you give me a clue where to find the overheat stats reset buttons please

This was installed new in August Its been working well but then I got this lockout code FO263 I tried pressing reset button but it didn't help so I turned the power off to the boiler for a few minutes then back on again and now I just have 2 short horizontal lines in the display. The...

Thanks very much for your help

That would be fine for now and maybe later I could wire in a switch

I don't' have a circuit diagram for the boiler. I could remove a link if you can describe where to look.

gjf60 New Member I have recently had a Worcester Heatslave II 18/25 combi installed in my kitchen After installation I told the installer I don't use the hot water and how to turn it off to save energy. He said just put it into Eco mode but not to turn down the DHW temperature on the boiler. I...

Its still working ok and I have been monitoring the current used to try and and see if the defrost heater is coming on. Does anyone know how often it should come on. I haven't seen any sign of it only about 0.4 amps when the motor is running

I have a Beko CF5533 frost free fridge freezer about 5.5 years old. The other day I noticed the noise from the fan in the freezer was slightly different but it was not blocked and later the food in my freezer was soft. It was running at about -5c The fridge at 4c about normal. It seemed...

Cant see any screws so I will look for slot for screwdriver thanks for your reply

I have a Micro Genius HE 24 boiler fitted with a Danfoss wall thermostat. The mechanical boiler clock no longer works so I plan to replace the stat with a new prog digital stat such as the Honeywell CM901. The problem is I cant get the old Danfoss stat off the wall. The dial can be easily...

Turned out not to be the compressor but a gas leak and after a couple of more goes the repair man gave me a refund as he guaranteed his work for 12 months which was very good of him. Bought new fridge freezer.

I ended up getting a repair man in. Said it was the compressor over heating and switching off. Debated scrapping but decided to let him fit new compressor £80 plus labour. He said it looked like it was made by Beko.

Any suggestions of what I can try next. Is it worth replacing the stat and if so where is it located.