Search results

  1. L

    Tarmac restoration

    Hi, a section of our driveway has had to be redone so it’s looking different to the rest of the driveway which has faded over the years. Would tarmac restorer work to bring the old tarmac to look like the new ?
  2. L

    BT Full Fibre Installation

    It could go under the suspended floor as BT did that last time. My master socket is in the middle of my house under the stairs, just want to know if this would need to be moved?
  3. L

    BT Full Fibre Installation

    No sorry, that’s what I’m trying to find out. What cables would need to change? And could the master socket remain where it is as the cable to it runs under the suspended floor
  4. L

    BT Full Fibre Installation

    Hi I can upgrade to full fibre from BT but have a few questions that I hope some members in this community can help with on pre-installation questions please. I would like to keep the location of the master socket where it is, which is under the stairs in the middle of the house because this...
  5. L

    Whirlpool Tumble - is this normal on the back of the tumble ?

    Hi I’m looking for advice and guidance please on my Whirlpool condensing tumble dryer. I’ve pulled it out today as it’s been moved in my garage and found that the felt on the back has came apart? Does this need repaired, is this normal and is there a risk of operating the tumble with the back...
  6. L

    TV wall mounted above fireplace - what about sky boxes etc

    Hi I’m looking to wall mount a 55inch TV above a fireplace (not used) to save space by not having it on a stand and would appreciate any advice and guidance along with any recommendations please. I did look at getting a media wall built but really like the marble fireplace and it would be a...
  7. L

    Blocking up void in fireplace to reduce draught and noise

    Thanks, yes I think so, the baxi boiler is not used - how can you tell? I have been using a Worcester Bosch system boiler and unvented hot water cylinder (both of which are in a different part of the house) for the past 5 years so I’m guessing the baxi boiler is disconnected? Yes if I put my...
  8. L

    Blocking up void in fireplace to reduce draught and noise

    Hi Behind our electric fire in the fireplace there is a void which is bringing in draughts and noise from the road outside. There was an old back boiler but this is not used and was replaced with a new gas system boiler when we moved in. How can we insulate this or block this up to reduce...
  9. L

    New Unvented Cylinder flow rates and temp fluctuations?

    Thanks all for your replies, really appreciate it. I think they measured it at the outside tap near to where the cylinder was going to be located. The 25mm blue main comes in and at the stop cock goes straight into 15mm copper, it then goes quite a convoluted way before the pipework ends up by...
  10. L

    New Unvented Cylinder flow rates and temp fluctuations?

    we have had a Gledhill 300litre unvented Cylinder installed by a G3 installer The problem is when we are in the shower and if someone opens another tap or flushes the toilet the temperature changes in the shower which is dangerous for the kids and adults - is this because it’s not a...
  11. L

    New Internal Oak Doors - Osmo Door Oil?

    Hi I am getting full boarded internal oak doors fitted today https://www.cheshiremouldings.co.uk/abbotsfield-full-boarded-internal-door/#finish_oak-mx838 I just wanted to ask is Osmo Door Oil https://www.osmouk.com/sitechaptern.cfm?bookid=Products&chapter=82&page=274 ok to use to finish the...
  12. L

    Bristan Varispeed 50 shower pump replacement advice

    Would this one from screwfix be ok to replace my existing Bristan varispeed And would it be a like for like install...
  13. L

    Bristan Varispeed 50 shower pump replacement advice

    would rather buy new. Is this one ok https://tapstore.com/ts-50-shower-pump.html Or are there better options?
  14. L

    Bristan Varispeed 50 shower pump replacement advice

    Hi We need to replace our Bristan Varispeed 50 shower pump which is on its way out. We just need a cost effective alternative that we could ideally replace ourselves. This will only be temporary until a new unvented cylinder is installed in the next few months. What replacement shower pumps...
  15. L

    Unvented hot water cylinder typical cost

    Ok great thanks. Would be interested in hearing your thoughts regarding this - are Gledhill any good? Will it require all new pipework from the new unvented cylinder which will be moved downstairs next to the boiler to the hot/cold water pipework around the house? I understand that all of the...
  16. L

    Unvented hot water cylinder typical cost

    Hi What is the average cost of the installation of a new unvented hot water cylinder ? We want to replace our existing vented hot water cylinder and re-site it from the bathroom to the boiler room downstairs, replace/re-run pipework and remove the cold water storage tank from the loft. We...
  17. L

    Impact on next doors new conservatory on our existing lean-to garage roof?

    Hi Our garages are joined with a lean-to roof which slopes down toward our house. Next door have said that they are going to replace the section of roof (that is currently the perspex roof section in the pics attached) with a new conservatory. What impact will this have on our existing garage...
  18. L

    Drain Relining Question with smell

    Hi ken Yes, don't think it's channeling it's a straight run under the floor The chemical smell is everywhere , to the point where you can taste it in food (cereals) etc that's in the cupboard and when using the fan oven How can you rectify the smell though, dig it back out?
  19. L

    Drain Relining Question with smell

    An update - the smell of the chemicals is still as strong as it was. So much so that you can smell it on the plates, even in the oven and in the kitchen cupboards. When they installed the drain liner they had to use cold water rather than use an air compressor or hot water, is this why the...
  20. L

    Drain Relining Question with smell

    Hi Ken Yes we had CCTV and there were some cracks and joint displacements. There are no junctions in the middle of the floor plan its a straight run to the chamber outside. I have read that it can take about 48 hours for the chemical smell to go? The floor in the kitchen where this line runs...
Back
Top