Search results

Thanks Hugh J. You were right - it was the cylinder stat- It was stuck, now released and set at about "5" but will need to get a new zone valve for the hot water. (The other one is just for the CH) and a cylinder stat ( Regulations - it would seem you are not allowed to replace the on pipe...

Just tested the Cylinder stat which is set at 5 (1-10) a grey stat, and the pipes are hot both sides going into cylinder, but it did not whir, and the pump did not change, when I turned it down and up again but that could be because the water, in the world of the stat, thinks it up to temp...

Hi Hugh, Its got a Honeywell 2 point zone valve ( Silver square box) The pipes both side of it are very hot which they should be. The pipe at the top of the hot tank has reached somewhat under room temp, but above cold now 8.00am till now 2.00pm today

I have an old boiler which worked brilliantly till recently. The Rads are hot and OK but I get no Hot water. The tank is hot and the pipes into it are hot, but No Hot Water at all. Over Xmas I put the timer on "All Day " and got some hot water but not full temp. Today back on "All Day" but no...

Can anyone help ! I am getting my kitchen re done and the fitter had trouble lighting the boiler pilot light after his gas work. He got it going eventually but had to remove the pilot light window and broke the gasket in the process. A small square grey plastic gasket. So now the window is back...

My garden shed is 6' x 8' apex roof made of chipboard and felted. For years it would seem, a tree has been burrowing its way into the roof but the rest of the shed is OK water damage is bad but that will dry out if I sort the roof and leaks. The roof will need to be completely replaced not just...