Search results

Quite simply will the 36/30 produce or exceed 24kw of heating power then.

ISo from the intergas boiler range what is the one to go for that will meet the requirements. Just to be sure.

where can yo get intergas boilers from?

Its a ground floor 2 bed flat from a traditional 9" brick built 1900 house. One bath with large shower head and additional hand held shower haed. There is an open plan extension of about 40sq meters with has wet underfloor heating and 3.6m doors. The extension is cavity wall insulated. The...

So flow DHW flow rates above maximum heating output, where as minimum heating output sufficient for total heat loss?

I am open/grateful to an explanation.

The installer recommends a 30kw boiler. The boiler choice is mine. Just wanted to make sure I was buying the right boiler.

I am going to go for an intergas combi boiler. ( I am not fitting it0. I am a little confused on a few of the outputs. For instance the have a 36/30, which you would assume has an output of 36Kw has an output of 26.6kw? Is that correctthat is has an output of26.6 kw? I usualy thout that combi...

Hi I just wondered if there were any other recognised schemes that would allow you to be legit with gas, apart fron being a gas safe registered. After all to be part P compliant as an electrician there are several choices, so why the monopoly with gas?

Is this a proper multi tool or just a revamped detail sander? http://www.hotukdeals.com/deals/bosch-pmf-180-e-multifunctional-allrounder-oscillating-multi-tool-with-cutting-discs-1424351

I was surprised at how much carbon was left on the brushes, Suffice to say there was plenty. Do the fauly codes happen automatically or do they have to programmed? The only other thing that bothers me is that when any program is selected the last thing flashing on the display is the figure 2.20...

I checked the brushes and they were contacting the armature and removed the and they were fine. I also checked for any blockages in the pump. Although the pump was full of, what seemed like pure liquid detergent, there were no foreign objects. I did notice that there was a bit of smouldering...

I have an evolution we12 that does not start. There are no error codes flashing. The door does lock but pressing the start button has no effect. Do you have to bring up the fault codes ?

Thanks Salad fingers but both faces will be visible and I want a square edge. I prefer to invest in a dcent tool, pref mains, so if use it for cutting plywood I would also use to dut down fire check doors without having to score the face etc. So the right blade is important for me.

awsome eply. Thanks vey much for all the replies. Big All is the dewalt that good. they always seem to go on about Festools or Makitsa rail saws

It's going to be quite a few cuts as i want to have a go at making some basic cabinets. I have a basic table saw and if that is not accurate enough I was thinking of investing in a plunge saw with guide. Big All is triple cut a blade brand a search brought up an american site and wondered if...

I am looking for a blade for a circular saw that will cut across the grain without it chipping off the veneer edge face. Any ideas??

what about AV tech. I had one 5 years ago , still running fine, but the user interface is is not very intuative. BTW what is D1 recording?

ans this is for the viola or the Dynamic. Sparky where are you based?