Search results

Our double patio/conservatory doors are jammed shut. The lock has always been stiff and you could only really turn the key by pulling the doors towards you when on the inside, or by pushing into them when on the outside. Now the key turns the same but the handle of the door with the lock...

Is it possible I've damaged anything when taking out the PCB? Seems unlikely as it's still the same fault and no new errors?

Not what I was wanting to hear. Could it be the same fault I've seen on here where it affects all the lights - the C17?

Wires were in the heater. Water was also heating up - could feel through the glass. Terminals gave a reading of 30 ohms using meter. Could it be the pressure switch?

Have used the site before - was hoping rocks1 might be able to help out again?

Had flashing lights - top and also on/off. Have replaced relays on pcb and connected all back together. Tried machine today and washed but would not go into final spin. The water begins to drain out and the washing enhance light starts flashing. The water finishes draining but the lights...

Okay Managed to replace relays on pcb and connected all back together. Tried machine today and washed but would not go into final spin. Washing enhance light begins flashing, top light of five, as it should start spinning. Then continues like this for a bit with the only noise being the...

Got it! Thanks for all your help yet again. Just hope I can put it all back together!

Should the connectors come away by hand or should I use pliers? Do seem awful tightly fixed - some not budging!

Okay - have managed to locate and remove screws. There looks like there are a lot of connectors linking to the pcb housing (assuming that's what the white plastic is) I'm also assuming I need to remove all of these? So far have only managed to free the broadest one that clips directly...

Looking at rear of machine there is one screw at bottom left and a small rounded cover above with two screws fixing it in place. Are the four screws you are talking referring to inside?

How do you remove the pcb? Looks awkward to get into?

Thanks for all your help up to now Measured with a meter getting a reading of about 31 ohms. Is that too high? I know you said 25 ohms before If not how do I sort out the relay on the pcb? Not sure where exactly the pcb is and what I'm looking to replace

Okay - can get a meter and know how to use one. Where is the heater and where do I connect the meter to?

Erm - how do I check the heater? Total novice at this

It's the washing enhance light that is flashing - this I know relates to the heater relay. Does this automatically mean I need to replace the pcb? Is there something else I should be checking first? Is this an easy fix? So many questions... :oops:

Great Thanks a lot!

Thanks - thought that might be it. Easy enough to fix?

Machine stopped spinning and door locked light will not come on all though door locks. After some footering I got the door working again, but stopped during final rinse and spin. Now it's back to door locks, cycle light comes on, door locked light stays off, cycle does not start. Anyone...