Search results

Hi, I am about to use the Dunlop Cement Based Wall Grout from Screwfix, however, the technical sheet says not suitable for power showers. I have a shower fed by a 1.5bar pump. It is reasonably powerful but not excessive and the tiles will only be on the wall - will this product be...

Hi, My shower pump is fed from the top of the hot water cylinder (appreciate that the side would be better) and the cold water tank and has worked perfectly. I have recently replaced some taps, which involved switching of the mains and draining the hot water system. The shower seems to be...

Thank you for the information - much appreciated. Its not a recommended installation so wasn't going to mention too much! ;-) Basically the pump is in-line with the old gravity-fed shower pipework in the loft. The original hot water feed is taken from near the vent pipe. Spoke to...

Thank you - much appreciated. On a similar theme, I need to re-plumb where the hot water is fed from because it is sucking air via the vent. This means that the pump only pumps cold when first started, then when the mixer is turned off and then on again it works perfectly. Any idea if...

Hi, I have a salamander twin impeller shower pump (CT50+) and was just wondering what happens if you have a cold shower? I.e. will is sense the cold water flow and run the hot side dry or can these pumps switch-off individual impellers? Didn't want to damage the unit by only running cold...