Search results

I have two ELV lights that were, until recently, powered by a small power supply. Both lights failed at the same time and after investigating with a multimeter I found that there is now no voltage output on the secondary terminals of the power supply. There is mains voltage at the input. With...

Hi, I recently purchased a no voltage release switch to operate a small lathe. There is a wiring diagram on the side of the casing and I am wondering if someone can help me by explaining what the terminal marked "A1" is for please? I intend to connect the line/neutral feeds to 13...

Hi, I have taken a look through the posts on here regarding a CCTV DVR system and two names have come up Samsung and AVTech. With this in mind could anyone give me a recommendation or feedback on use between the following: - Samsung SRD-443P - AVTech KPD675D - Securix SME4 I would be...

I have a 6kW induction hob connected to a cooker outlet in my kitchen. The cooker outlet is fed by a 32A MCB via a cooker isolator. The circuit is protected by a RCD. I also have a 2.3kW oven which I would like to connect to the cooker outlet. If I replace the cooker outlet with a dual...

Hi, I am looking for some advice regarding a hedge trimmer. I have a fairly deep hedge and have difficulty cutting the far side of the top. At the moment I am using a step ladder, balancing on the top two steps and using an electric hedge cutter with a 60cm blade. This gives a nice finish...

Hi, I was wondering if someone would be able to advise me please? A new boiler was fitted to my central heating system around 2 years ago by British Gas. The new boiler is a Worcester and, unlike the boiler it replaced, has a pump overrun feature. Around a year later the pump failed and...

Hi there, I was wondering if you could help please? It has been recommended that I fit a magnetic filter to my central heating system (I have a newish boiler and an old system). The central system is a vented type with a condensing boiler. I was therefore looking for recommendations on...

Hi, I am wondering if someone can offer some advice please? I have a 12v power supply which I will be using to provide power to a single light fitting (LED). The power supply was not provided with any instructions and has bare wires ready for connection to the power supply. I have...

Hi, I was wondering if someone could provide some advice please? I have a ceramic hob which I would like to replace. It is a 6000W model (based on label under the hob) and is supplied by 4mm2 cable from the CU via a DP cooker switch and connection point. The cable run is approximately...