Search results

  1. G

    baxi has mind of its own

    If the boiler is fitted in a cold location it could be the frost stat bringing it on.
  2. G

    POTTERTON LYNX ELECTRONIC PROBLEMS

    Yes. you will find the insulation is cooked to a crisp, Cold the continuity will exist as they get hotter they break down .
  3. G

    POTTERTON LYNX ELECTRONIC PROBLEMS

    The leads (yellow :?: ) to the air flow sensor can break down due to heat in the combustion chamber and this causes the symptoms you describe.
  4. G

    hot water baxi 80 econ

    No not the case as the sensor on the eco senses boiler temp not dhw temp .
  5. G

    hot water baxi 80 econ

    possibly sludged/scaled up plate heat exchanger or temp sensor
  6. G

    Confirmation of Boiler wiring please on Baxi PFL 60

    I understand what you are saying , but the worst case scenario is that the pump fails to run when the boiler is being called for and the boiler cannot get rid of its heat at all and the heat exchanger splits and floods your house. As i said before it is the responsibility of the installer to...
  7. G

    Confirmation of Boiler wiring please on Baxi PFL 60

    You shouldn't need to know where the wires go, that is up to the installer if he has not wired the boiler correctly he has not upheld his part of the deal, give him money and he installs you a boiler as per manufactures instructions.
  8. G

    Baxi 105e combi, fan problem

    If the fan sounds normal it is either the air pressure switch of some form of debris in the fan venturi.
  9. G

    Baxi Bahama 100 cuts out after 20 seconds

    FLOW SWITCH sorry that i shouted
  10. G

    resetting the pressure on potterton profile e60

    Sounds like the ball valve in the small tank in the loft is stuck (system not topping up) or worst case cold feed is blocked.
  11. G

    resetting the pressure on potterton profile e60

    Sounds like the ball valve in the small tank in the loft is stuck (system not topping up) or worst case cold feed is blocked.
  12. G

    resetting the pressure on potterton profile e60

    Sounds like the ball valve in the small tank in the loft is stuck (system not topping up) or worst case cold feed is blocked.
  13. G

    powermax 155

    The central heating pump has probably seized try undoing the silver screw in the middle of the big round bit on the pump on the left hand side of the appliance and spinning the center of the pump (beware as water will come out of here and could be HOT). If this doesn't work and you have power to...
  14. G

    Range Powermax 155 - No HW

    This problem sounds as though it is a plate heat exchanger or blending valve problem if you were in a hard water area this would point to a scale problem. As you are in Staffs. I would probably look at sludge being the cause or that the thermal store is not getting up to temp. Bite the bullet...
  15. G

    Baxi solo 2 Pf 50 - Burner fails intermittently help plse!

    If the indicator light for the pilot stays alight I would check the electrode & electrode lead.
  16. G

    Potterton Suprima 100 with a hole?????

    The insulation is there to stop the case of the boiler overheating. It will need replacing.
  17. G

    Potterton Suprima 50 noisy

    The noise you describe is probably due to a build up of system debris in the heat exchanger. Try fernox system restorer or equivalent. Either that or remortgage and fork out for a system power flush.
  18. G

    Baxi 80 Eco problem

    The british gas option is only £130.00 if you get both your gas & electricity from b.g.
  19. G

    baxi boiler

    The pressure on your baxi nemesis should bar 1.5 bar.
  20. G

    Baxi 105e.

    The blocked air vent is a product of the real problem which is the sludge in the system that if installed as per the installation instruction & been flushed.
Back
Top