Search results

I can only find white and brown magnetic contacts. I need to fit one to a grey/anthracite coloured bifold door. Does anyone do a range of colours? If not, surely there must be an opportunity for someone!

Hi, I am presently redecorating and want to replace my Response wired 4 zone alarm panel, as its yellowing and looking rather old fashioned. Problem is that every other panel I see also looks out-dated and ugly! Best I can see is perhaps the HONEYWELL ADE OPTIMA COMPACT 8EP396A-UK but I was...

Thanks Andy! I will take your advice.

I am planning the building of a covered decking area approximately 3.5m2. I plan to use 3.6mx100x100mm use class 4 graded gate/fence posts at the corners cemented into the ground, a decked floor attached to a joist frame between the posts and then a sharply sloping roof with external grade...

Thanks Dean and Picasso. The situation is exactly as you have stated. Funnily enough I actually searched for a digital without a battery as I did have one previously but it ate through the duracells like they were smarties. So I thought the Heatmiser DT would be a good replacement as a basic...

Pics attached. From left to right cables are:- - To heating and hot water timer controls - Mains input - Tank stat - Room stat (where I had moved yellow cable from 4 to 1) - CH pump - Motorised valve - Boiler Thanks for your help with this, much appreciated.

Heating wiring

Ah, no it's not. Now my heating turns on with the thermostat and is by-passing the heater timer controls. If I have to put it back the way it was and have the stat powered via the heating controls I will, but I suspect that something else is not quite wired in the usual way Any further...

Thanks Denso, all sorted!

I have replaced my manual room stat with a Heatmiser DT digital stat for my conventional GCH system. It is working OK, but the stat only has a live feed when the heating is activated, so is powered down at all other times. The stat has a 3 wire plus earth feed. At the junction box of all...