Search results

Hi guys, Apparently my downstairs Tado is triggering both zone valves to open (light is on and radiators in bedroom are warm). This issue doesn't happen with the upstairs Tado. Any ideas what I might have done wrong with the installation? Thanks!

What gauge stainless steel do I need to be looking for to improve the sturdiness of the sink?

Hi guys, I have a new build with a fairly cheap sink. Does anyone know the gauge or stainless steel they tend to use? It is a "Leisure" branded sink but I don't see this one on their website - must be too cheap. My problem is that I've installed a water softener and have a three way tap...

Hi guys, My decking is 4.2m wide while the garden is 4.45m wide. This leaves a 10-15cm gap either side of the decking (315cm length). My original plan was to fill it with white cobbles topped with small white stones to give a border either side. Solar lights would then be placed in the...

Hi all, I built decking in my garden last week when it had been nice and sunny for a few weeks. I managed to get down the frame and around half of the boards, using 5mm cuts of wood to space each board. The problem came this weekend when I went to lay the rest, the original gaps had grown to...

I didn't think of that! Thanks. So the plan was for the 4.2m x 3m frame built in the middle, right at the back. Are you suggesting I extend the sides of the frame to the fence posts to contain the stones? Sorry, I might be misunderstanding. The image below might clear it up. I only planned it...

The decking will be as low to the ground as possible. So I will build the frame on nine 60x60cm concrete paving slabs and will check for the level first. The garden currently naturally slopes right to left so I was planning on leaving a slight gradient for water run off. It sounds like you...

Hi all, I have decided to deck the full width of the end of my small garden so that I can use it for seating and a BBQ area, and would be grateful if you could answer a few questions. The decking will be running parallel to the house, using 47mm x 150mm joists and 150mm boards (machined to...