Search results

Hi, i have a large piece of glass i'd like to fit to the wall as a kitchen splash back, i had 6 holes pre drilled and i was planning on using a mirror type screw and raw plugs. The holes drilled however are 10mm in diameter so standard screws will just pass right through. Are there any kind of...

Hi i'd like to fill in some gaps with plain white 6" tiles in my bathroom tiling after installing a new suite but i have a couple of questions relating to the pics 1. Do i tile down to the bath and seal off or is it better to move the bath out, tile below the bath line and replace bath. 2...

Hi i'd like to fill in some gaps with plain white 6" tiles in my bathroom tiling after installing a new suite but i have a couple of questions relating to the pics 1. Do i tile down to the bath and seal off or is it better to move the bath out, tile below the bath line and replace bath. 2...

I ran the shower and the pipe on the far left got red hot and the two next to that one warmish. I'm not sure about flow rates only that i can't have a reasonable shower! thanks for the responses

Hi I have an ISAR HE24 combi boiler approx 4 years old, hot water varies in temperature depending on speed, so if i want a hot shower its a dribble, any enjoyable power and it gets cold..... takes a looong time to fill a bath too! Any advice on things to check? Theres a pressure gauge with...

I have a 22mm copper pipe supplying water to my bolier. It runs up one side of the house (inside) across the loft and down into a combi boiler in the bedroom. I have a small leak at a join in the pipe in the loft. I've located the stop cock in the garden and one just before the boiler. I'm...

I'd like to fit an extractor fan where the vent is in the picture, obviously the current hole will be too big so i'll need to make some kind of mounting plate? What can i make it from, wood/tile/plastic? Also has anyone installed one with humidity sensor? Do they work? Thanks

Im carrying out some work in my bathroom and i'd like to remove an old bath keeping the old tiles and tiling up to the old ones with new. My question is are the old tiles likely to fall off once the tiles/bath below them are removed, I'm guessing they should stay stuck as they've been up...