Search results

  1. S

    1 way and 2 way switches top and bottom of stairs

    Hi all, Current setup is 2 gang 2 way switch at bottom of stairs, one switch operates hallway lighting and other switch (2 way) operates upstairs landing lighting. At top of stairs is a 1 gang 2 way switch which also operates the upstairs landing lighting. My question is, can I change the...
  2. S

    Boarding single skin wall in porch

    Hi everyone, In the process of renovating the hallway and porch area, ripped out the poorly constructed internal wall and door, will be replacing wall and fitting external grade door so no building regs to worry out. (Was thinking of having open plan but too much of a fuss and already small so...
  3. S

    Bathroom with stair bulkhead

    Hi guys, Going to start re-doing the bathroom, need some ideas for what to do with the staircase bulkhead. Photos attached. Happy to have the toilet and sink in the existing positions. Planning to get rid of the bath and just have a shower to free up space. I was thinking either keeping the...
  4. S

    Laminate up to UPVC door

    Hi all, I’m currently doing the living room, going to be installing laminate, can anyone recommend what’s best to transition up to the patio doors. Currently there is a length of board against the UVPC but I would like to remove it as it’s worn. Could replace it with similar but I’m probably...
  5. S

    Disconnecting PIR permanently

    Then it’s definitely not wired correctly!
  6. S

    Disconnecting PIR permanently

    Thanks sparkymarka. Should the alarm have gone off when I took the case off? As there’s a tamper spring inside...
  7. S

    Disconnecting PIR permanently

    Hi all, I am renovating the living room and want to remove the PIR sensor permanently. The alarm system was installed before we moved in and we’ve never had any codes, only key fobs. The alarm is never used due to having pets. Could someone let me know if I’m ok to just snip the wire, and...
  8. S

    LED driver requirements

    Exactly where it is now! That setup is enclosed behind a cover, it’s not exposed.
  9. S

    LED driver requirements

    It was connecting the incoming supply cable to the driver.... the wire is out because I disconnected it.
  10. S

    LED driver requirements

    That is because I have disconnected it.
  11. S

    LED driver requirements

    Here is the product from RS. https://uk.rs-online.com/mobile/p/led-linear-arrays/9033018/
  12. S

    LED driver requirements

    This is how it was fitted.
  13. S

    LED driver requirements

    Hello, I’m having trouble choosing a compatible LED driver to power this LED strip. Originally I used this driver, the LEDs were very bright but the strip became very hot and burnt out the LEDs very quickly. The website stated this was 60w output, and the ratings all seem to match the LED...
  14. S

    Texecom premier 816

    Ok thanks, they are flashing rapidly at the same time as each other - rather than slowly and alternating, just seems a bit much.
  15. S

    Texecom premier 816

    This is the unit outside, the 2 red LEDs are at the bottom of the white section. Can't see them in the daytime.
  16. S

    Texecom premier 816

    Hi all, Just bought a house with a Texecom Premier 816, managed to set the panic alarm off... Silenced the alarm using the prox tag and it seemed to reset ok, although the external unit has 2 red LED type lights that are flashing rapidly, seems a bit much if it was normal operation so could...
Back
Top