Search results

Evening all, planning on plumbing in 2 column rads into a combi system (only 5 rads on the system, used to be more) and wondering if it's acceptable to tee them both in on one feed and return, given they will be "back to back" on either side of a stud wall? Room B may be fed through the wall...

Edit: apologies, think this should be in the plumbing thread, have reposted - mods please delete this

Hi, I'm looking to replace my UPVC front door with a newer composite - currently UPVC door and frame, with a pair of 320mm glass panels on both sides with midrails. I would prefer a thinner full-height glass panel either side of the door as I think it looks more modern and slick, but will the...

Hi, I took up some old thin 5/6mm laminate from our hallway in order to lay a better version 10mm thick + 5mm green underlay. The old stuff was laid over the original vinyl tiles from the early 70s and unfortunately the subfloor levels are out in a few places by 12mm... I threw down the new...

Hi all, We bought a house with a single skin garage converted into a bedroom w/ensuite (not sure when it was done, less than 10 years ago certainly) - the inner walls are studded with insulated plasterboard. We are replacing a cheap jacuzzi bath from the ensuite where it currently sits under...

Hi all, Hope this is the right subforum for this; I'm replacing a dodgy old whirlpool bath (Mrs is a bit funny about all the holes and jets) with a reinforced acryclic one. It's an offset corner due to the size and position - I'm going to build a frame (probably tanalised 3x2), ply on the top...

Hi all, would appreciate any advice on what the cause could be. Worcester Bosch Highflow 440 (older non-CDI version), CH connected to a wireless Honeywell thermostat (BDR91 relay), works fine when it calls for heat, CH duly kicks in. However whilst the CH is on and there is a demand for DHW it...