Search results

Purchased a replacement carburettor and petrol tank for a true shopping petrol multi tool as it was leaking petrol. No issue replacing carburettor however cannot get the 2 lower screws out to remove the petrol tank to replace it. All other screws very easy to remove. Not tight at all. These...

How difficult is it to replace the back plate? Do I need an electrician or should I be able to do this myself?

Thanks for the reply. When you say 'sjoild' fit the back plate. How sure are you? Ideally don't want to have to mess too much with wiring?

Can anyone suggest a replacement for the Randall 922 that could be replaced by a novice diy-er? Boiler is still going strong. Boiler Ideal Icos has had new PCB board, spark plug and generator and fan over the last few years but the timer bit seems a bit tempremental. Hoping something is...

This has been working fine but now the leds on the bell box have suddenly stopped working. Checked the loop out wiring...all seems ok. Any other ideas guys????

Thank you for your time!

There is a tamper at j5 but this is for remote keypad. The tamper on this is not linked out. Battery has never worked in it. Bell box cover was removed in summer for painting. Was ok for a while. Think damp or back plate tamper is at fault. Just need to know if i can connect the t and a wires...

Not quite sure what u mean by global tamper circuit. Looking at the board there is a tamper for the panic button. A tamper for the sensors. And a tamper for the bell box. The tamper for sensors is looped out so doesnt look like that has been connected. The t and a removed from the panel are for...

We have a accenta /optima alarm. The tamper kept going off. We have removed the wires for the bell box tamper and put a loop in. The alarm seems to be functioning ok but the leds on the bell box are not flashing. So from the outside looks like its not working. Queation is...can i leave the t...

OMG. Dont mind paying at all. But dont want the pi55 taken out of meo_O

Thanks. I am aware of that. But just had an elderly friend taken for a ride with a company out of the yellow pages. Will be asking for family and friend recommendations.

Thanks all for your replies. Dont think its the casing...already pressed all the panels whilst boiler was humming. Will will look for a plumber who is ideal boiler savvy!! Just thought I would ask in case it was a quick fix before the plumber tries taking the mick out of me. Thanks

Have an ideal icos boiler. When its been on for 10 mins or there abouts. It begins to hum quite loud as you can hear it from other rooms. After its hum for 10 to 20 mins it goes quiet again. Thinking its the fan? Is it dangerous to run like this? And is there an easier fix than replacing the...

Have an ideal icos boiler. When its been on for 10 mins or there abouts. It begins to hum quite loud as you can hear it from other rooms. After its hum for 10 to 20 mins it goes quiet again. Thinking its the fan? Is it dangerous to run like this? And is there an easier fix than replacing the...