Search results

Thanks very much

Thanks Secure I Am The switch will be around 60 mm and the cable a similar distance…. It’s on a a humidity sensor so there will be power permanent live in and out of the switch albeit low current. Del

Hi 9 months ago renewed alarm with wiired Texecom Premier Elite and Texecom dual sensor in kitchen. All working great. Building inspector wants an extractor fan in the kitchen and wiring for the isolator switch will be close to the sensor and cable of the dualtec sensor. Is that a problem or...

Thanks guys……hadn’t thought of a plug-in remote controlled device and yes Murdochat- need BCO sign off….Alas it’s an island with floor now tiled etc….But if I have read correctly as long as the extractor is in the kitchen and I use a more powerful one and vent outside the bco should sign off...

I presume I have to have an accessible switch in the Kitchen and yes its a recirculator....

Thank you all for taking the trouble to reply. Have done some investigation and could have a lucky escape..... Where the fan can go (presumably anywhere near the hob) is in the area with a loft cupboard so accessible. Can run the ducting to the soffit board easily. There is also a 13 amp...

Thank you Murdochat and Blup=Good tips

Final inspection by B Control and the inspector told us that we have to have a mechanical extractor in addition to the downward sucking recirculating AEG Hob extractor. All wiring done and signed off by our builders regular Spark. I can take power supply for one off the lighting circuit and...

Perfect Sparkymarka-sorted Thank you very much for taking the trouble to respond.

So with good advice thanks SecureIAm and SparkyMarka the system is installed and have tested at the weekend with the Wife in the Garden. Works ok. But, struggling with night time part set. Night time I want to have the Garage (Texecom DT) and patio doors - (normally closed CQR sensors)set . So...

Brilliant, thanks Sparkymarka…..

So all PIR's etc fitted and last lap is bell to panel .Bell was previously connected to Gardiner Panel and dont want to blow it at the last lap so before I power up can I ask the experts. Looks like the same 5 terminal on both the panel and bell..... See pic of panel and bell box...

Thank you very much .... Will go for CQR

No- its 2 patio doors. Entrance is into a hall with a PIR. Thanks

The day has come to get the rest of the kit to fit my Texecom alarm. Premier elite 24 Wired system -thanks Sparkymark for recommendation- with 7 PIRs( CAPTURE-) and a door contacts. Oddysey Bell fitted on old Gardiner system, so all Texecom. Re-using original 6 core wiring. Could I have a...

Thank you secure I am - spot on. Turns out the little fuse on panel had blown too….. Little light flashes and I think if I set it we should be good. Can’t thank you enough. Derek

So did my research on here and thought I did it right. Made the rookie mistake of not putting the panel into Engineer Code beacause I dont know it. No light on bell or strobe and now panel seems to be dead. The keypad has no light on it. I have checked fuse and that is ok. Current on all Zones...

Hi Guys Finally got around to changing system over to Texecom Panel as recommended by Sparkymarka and first step is new bell as weather dry - so going from old bell to Odyssey 3 Wiring in existing Gardtec panel shown along side terminals on new Texecom Bell - At this point if all I have is...

Thanks Secure iam - Much appreciated

Thanks for reply~ 6 zones with Pir s and one with patio door contacts , 2 sliding patio doors are next to each other so wiring them together on the same zone….. Was going for Oddysey 3 bell ? Derek