Search results

Good evening All, I have a Galaxy Aqua Digitemp pump on my shower, and have been having problems with it, in that the water stops flowing due to what seems like air in the system. By the way, all my hot water taps bubble and gurgle for a while when first turned on, clearly air bubbles there. So...

Hi Vitch, Thanks very much for your message, and detailed information. I have actually seen that process in the user manual, but had wondered if that would be the right thing to do, as it seemed to indicate being done when installing the system, or after working on it it. Mine works just fine...

Hello All. Please can someone help. I have a Galaxy Aqua Digitemp pumped version which works pretty well almost all the time. Every so often, though, it seems to run out of water. When that happens, I can’t hear the pump whining, but there’s no water flow. Both hot and cold water are still...

Thanks Andrew, much appreciated.

I ran the heating again for a short while, and the valve went to the full heating only position, so all OK there. However, when I turned the heating off again, the valve remained in the heating on position. A little while later, I turned the hot water on, and the valve immediately reacted and...

Yes, it does, and this morning, after both being on, the heating went off first (room temp reached), and the water on schedule, and the valve is now in the water only position.

Hi Andrew. Thanks once again for your excellent advice and assistance. I've done the installation and all seems to be working. I note, however, that the valve actuator (it's a Drayton MA1) is staying in the "heating only on" position, rather than returning to the "water only on" position that it...

Hi Andrew. Thanks very much for that. Too busy at work today, so will have to wait until tomorrow to do it.

Hi Andrew. Yes, it does, but the existing wireless receiver needs to be taken out of the equation, which results in some wiring needing to be changed.

Hello friends, I'm looking to install a Hive dual channel (for CH and HW) in place of my existing British Gas Model UP2 Programmer and WR2 Wireless Receiver. I've already looked at a number of posts on this forum, but found that the wiring in my installation is different from what I've seen, so...

Thanks for the advice, Pete. Will do.

Hello friends, I'm looking to install a Hive dual channel (for CH and HW) in place of my existing British Gas Model UP2 Programmer and WR2 Wireless Receiver. I've already looked at a number of posts on this forum, but found that the wiring in my installation is different from what I've seen, so...