Search results

Unbelievably, it was just the reseting of the nest controller that got it working. There's a day I will never get back. Thanks for the suggestions

Set up attached. I have reset my nest panel and hot water is now leaving the boiler but not making it to the diverter valve pipes.

Hi A bit puzzled at the moment. I removed a section of central heating pipe that had a screw put through it. Since then we have had no hot water or central heating. To solve the issue so far I have done the following: - Bled all the radiators (alot of air released from those near the fixed pipe...

Hi I have a pressure gauge on the outside pipe just before it enters our house. It has started leak. Is it just a case of turning the water off then swapping it for a new one. Do I even need a pressure gauge or could I just close it off? Thanks in advance Kev

Thanks I can't locate the other of end of the wire so will have a think about the easiest alternatives. Appreciated

I have a couple of these outlets by windows in the kitchen and bathroom. One is currently attached to a working extractor fan in the bathroom so I assume the one pictured did the same in the kitchen (wires are still live). My question is...can you buy blanking plates this size and also working...

No leaks so looks like it did the trick

Went with ptfe tape and feels pretty tight. Water goes on tomorrow so will find out then

None, just some lsx

Second attempt at picture

Hi Experts I am replacing a leaking drain of valve. However when I screw it in to the radiator it does not tighten in suitable position. I.e. drainage point facing up and the screw to open valve against the wall so you cannot reach it. If I leave it in suitable position it is not tight. Any...

We have a winner. The hours lost due to a 2cm piece of bridging wire that I forgot about ‍♂️‍♂️‍♂️

Zero for all of those

I have put things back as they were and still no power. Changed bulbs, bulb being used works in other light fittings so didn't blow.

Traced the wire from one switch to the other but the wire that feeds power to them disappears in to a wall I can't access. I would be surprised if there was a junction box hidden between that point and the fuse box.

Can't find the source. I am pulling up floorboards to try and trace it but not found it yet.

Have a multimeter which is showing no voltage. Shows a voltage for the other light at the switches. I am in the process of fitting wireless light switches. It was working but something has had a knock on effect. Not sure what though.

Hi I am a bit puzzled that one of my lights is not getting power at either light switch. The light is at the top of the stairs controlled by a light switch at the bottom and another one at the top of the stairs. Both switches are doubles with the bottom one also controlling living room light...

Hi Everyone. I have removed a broken extractor fan from our bathroom window. The issue is that the fan is overly large and to be fitted a 7 inch (diameter) hole was cut in to the window. I would ideally like to replace it with a smaller fan and was wondering what my options are besides replacing...

Hi We are renovating a small bedsit and the kitchen wires are all exposed and a bit of a maze. I have traced most them them. However, the once circled in red comes from upstairs into a black junction box and back the same way upstairs. What is even more confusing is it is wired up with the...