Search results

Hi, I have just noticed the brick supporting the wooden shed base has broken which resulted in the base being lowered. I don't have a car jack that would fit this low. I was wondering if there any useful tips on how to lift the base whilst putting in support underneath. There is concrete...

I have a service agreement with a provider who looks after the boiler however they are unable to obtain one part from Vokera as its no longer in stock. I have seen a photo of this part: a small PCB with components and a 4 pin connector. After reviewing the installers manual, the only 4-pin...

Hi All I rent out a property (flat) - and was informed today there been attempted metal theft of the external gas pipe from the meter leading to the inside of the property! :twisted: It has been fixed by a gas safe guy today. I have seen the damage and it looks like a clean cut and I...

Hi - I have the vanity unit - should I fit the cistern on the wall below the top bar at the back of the vanity unit? There is a mounting bracket with the cistern - it's a plastic bracket and I am uncertain if this alone would support the cistern weight when filled with water? Should I...

Hi - I have the stone shower tray which are fitted with riser legs. It's to be installed on top of a new vinyl floor - then I thought, should I cut off part of the vinyl where the riser legs is standing on? My thinking here is since vinyl floor is soft and the riser legs may press down the...

Hi - I am going to replace the plasterboard in the bathroom in the loft. What type of insulation should I use, there is a gap of about 500mm from the party wall (in roof) to where the stud wall is. There is nowhere to secure the new blanket of insulation unless I put some sort of plywood on...

hi - I am about to install new shower on the adjacent wall from where the old one used to be. Cabling and plumbing already there - just needed to re-route both to that wall - this is not a problem. Walls is plasterboard. What is the ideal position of the electric shower unit? I am...

Hi. just found this neat forum. Right I have checked the brushes and there are good continuity between brush end and the wire, plenty of life left in brush. Have checked the clear tubing for any leaks leading up to the pressure switch (is it called this?) Belt is fine. It may be...