Search results

I have a salamander esp 100 shower pump. Its configured for negative head, even though I have a positive head setup because the response time in +ve head mode is too slow (1sec+ between tap open and pump fire) The shower head is about 60cm below the cold tank which is in the loft directly...

I currently have 3 bar salamander ESP 100 CVP shower pump. Its located at the base of the cylinder and when it kicks on.. it can be head through out the house. I am expecting a baby soon and it will be sleeping in the room with the pump so I need something quieter. Also I have this odd...

I have a glow worm 60 mk11 boiler and I cant get it to relight. It went out yesterday, and now it wont re light. I took the cover off to see if I could light the pilot with a match (have done this before).. but this time, when I hold down the pilot button.. no gas comes out. The gas supply...

I am about to tile my bathroom floor. Currently its just regualr floor boards. I have been advised to cover it with a layer of wood before tiling it to give a flat base. What wood should I use and what thickness? I was thinking of 12mm chip board. Amit

Do expansion pipes from the top of the cylinder have to loop up over the water storage tank and come down from above? or can they be fitted to the side of the tank above the water line? I have new sealed tank to install and it would be easier to put it in the side a little higher than the...

I am fitting a new bathroom and plumbing in a 3bar salamander house pump. Is it ok to connect the pumped feed to the toilet. The pump manual shows its ok if the toilet is fitted with an equilibrium ball valve. Not sure what one of those is. I have a single flush cistern and S frame from...