Search results

  1. C

    Siemens Dishwasher Top Spray Arm Not Turning

    ok great have orded another http://www.casaparts.co.uk/products/id-19071020
  2. C

    Siemens Dishwasher Top Spray Arm Not Turning

    checked that , the water is just slowly trickling through the upper spray arm
  3. C

    Siemens Dishwasher Top Spray Arm Not Turning

    I have an issue with this Siemens Dishwasher SE25M275GB/36 Upper Spray Arm not turning . Everything is working except for this. Spray arms are clean and no blockages , manifold clear too Motor was siezed but i unsiezed it and now it works fine . any ideas ???
  4. C

    INDESIT WIDL126 WASHER/DRYER Dryer not working.

    the dryer manifold is on the top . check the wires there is usually the temp limiter as a place to start
  5. C

    Belling IDW 604 Dishwasher

    does the water get hot ?
  6. C

    Bosch Classixx Dishwasher - Not running through programme

    motor possibly siezed either free it or get another what is the model number
  7. C

    Bosch Dishwasher Not Heating SGS4012GB

    hi Phil It is part of the assembly but some places sell separate http://www.casaparts.co.uk/products/id-04100910
  8. C

    Hotpoint Ultima WD71 front panel buttons

    it did :D
  9. C

    Belling IDW 604 Dishwasher

    possibly a motor failure or a leak from the motor have a look underneath at this part http://www.casaparts.co.uk/products/id-15041006
  10. C

    Miele G646 dishwasher stopping

    Hi I have come across a confusing intermittent problem on the machine mentioned in the title switch the dishwasher on and it Drains Fills the motor starts , then it just stops, leaving inlet and otlet light flashing checked the motor it works fine and no debris inside the housing the...
  11. C

    NEFF Dishwasher spray arm trickle

    sometimes can be bits of paper and plastic blocking the motor impelloer rotors. Take off the outer casing to reveal the impellor and clean out the little lugs caustic soda - sounds very entertaining :evil: :shock:
  12. C

    Bosch Classixx Dishwasher

    Dishwasher always a cold feed only
  13. C

    Bearings fitted to a Hotpoint WF840

    :roll: driller thriller 8)
  14. C

    Bearings fitted to a Hotpoint WF840

    its a case of go for it - nothing to lose :shock: :shock: :shock: :shock: :shock: :shock:
  15. C

    Bearings fitted to a Hotpoint WF840

    heat will do it blow torch on the bearing hammer it with a screw driver from the opposite side it will shift - battle of wills
  16. C

    Indesit W103 wont Drain + Dial Spins + Parts fell off?

    Wow , never seen that before. guessing that the transit bolts been left in and just caused major issues with the machine ????
  17. C

    Bosch Classix 1200 Washing Machine

    you need to clean the dispenser tray and compartment. looks like this http://www.casaparts.co.uk/products/id-11021014
  18. C

    Freezer in shed questions...

    I have had 1 in my shed for 5 years and never had an issue yet. i have 1 in the garden at the moment too, works fine
  19. C

    Bosch Dishwasher

    check the wiring is ok to the pump can be seen from the front or off the left side looks like http://www.casaparts.co.uk/products/id-25080906
  20. C

    Smeg D1612C Dishwasher

    For the soap dispenser take the front door panel off and check the wiring to the dispenser looks like this http://www.casaparts.co.uk/products/id-31011011 Might be worth checking the element and or thermostat looks like http://www.casaparts.co.uk/products/id-31011001
Back
Top