Search results

Hi wondering if anybody can help we have a Biasi m90f 28s combi which is running fine apart from a problem that has developed. when the water in the heating system reaches its high temp setting (about 65c) it shuts the flame continues circulating as it should. Then after about 20 seconds flames...

Hello again looking for some advice regarding the siting of an external expansion vessel on my CH system. the present system has been recently extended and the capacity of a couple of the existing rads increased. we have noticed there has now been an increase in boiler pressure when it has been...

Hopefully somebody can give me pointer to save Christmas dinner. our Samsung BF3ON3T11 built in oven has developed a fault. When using the oven it will run through the pre heat cycle warming the oven but when that finishes and you switch to either top or bottom oven in fan or conventional mode...

Hi i have a biasi m90 f combi about 5 years old which is running fine in CH. But when you ask for DHW unless you strangle the flow rate through the tap the temp is only tepid. Had a bit of a closer look this morning before the CH had been fired up. Water took a while to get any heat in it...

My 406 fuel filter located under the car near the offside rear wheel has started to leak. Does anybody know how to remove without damaging the fittings on the fuel line. Thanks

Hi Need some advice i have a Biasi M90F 28 combi boiler. Arrived home today to find CH not working. The boiler trys to go through the start up procedure for a few seconds then shuts down. The green operation light flashes at its normal speed about once every 3 to 4 seconds and the lock out...

Need help or information urgently please. Bought this machine new in May so it is still under warranty. It has started making a loud knocking/scraping noise on the spin cycle. The noise appears to be caused by something between the inner and outer drum. A daft question but would this be covered...

Looking for some advice. This is the 1st winter we have had in this house. It is heated by a Biasi M90F 28S feeding 7 rads over 3 floors. The last 4 digits on the boiler are 1103 which i understand means built in 2003, but the rads in the system look older making me think they were not installed...