Search results

  1. R

    Under Floor Heating

    Hi I wonder if you can help I just installed aube technologies TH132/AF under floor heating in a conservatory under ceramic tiles. It has been on now for 2 hours and the control panel is only showing 14.2degrees C and the floor still feels cold. On the load terrminals 2&4 there is a note that...
  2. R

    Remedial Work

    It seems that way. Its just on the report it says We recommend that this installation is further inspected and tested after an interval of not more than 1 year provided that any items at G which have been attributed a Recommendation Code 1 ( requires urgent attention) are remedied without delay...
  3. R

    Remedial Work

    Hi I own a property which i rent out via a letting agency. The agent had a niceic inspection done on the property. On inspection there was a few things picked up 1 No cross bonding under kitchen sink code 2 2 No local isolation switch for...
  4. R

    radiators not getting hot upstairs

    Thanks for your prompt reply. I have fitted all new radiators upstairs (the problem was there before) Where will i find the trv valve please? and is it required? ive tried closing all the other radiator valves makes no difference. I also tried putting a bucket under the valves and turning the...
  5. R

    radiators not getting hot upstairs

    Hi I live In a 3 storey property the combi boiler is on the ground floor, the radiators on the middle floor get warm but nothing like as warm as the gound floor. The radiators on the top floor only get luke warm, I have tried bleeding them over and over again makes no difference. The way the...
  6. R

    Diplomat

    Hi thanks for feedback can you reset the thermal overload?I take it the pcb is the main circuit board? Would that cost more than the the machine is worth to replace? (i think machine is about 2 years old)
  7. R

    Diplomat

    Washing machine drum wont turn, machine will fill up and empty.removed back of machine the motor is not running. I removed and checked brushes they were fine. If you put a neon screwdriver on the brush terminal with the machine in spill cycle the screwdtiver lights on both brushes showing ther...
  8. R

    upstairs ring main

    Thanks for your feedback i was never passed the installation certificate when i purchased the property.I did find one more power point with only one cable, in the loft conversion but that also went dead with the rest of the circuit, when the one cable was disconnected. so that is coming off the...
  9. R

    upstairs ring main

    Can anybody please help? i have a property which i rent out the letting agency which manage property just had a annual inspection done on the electrics. it has come back with no continuity on upstairs ring main on all three cables the property was rewired about a year ago before i purchased it...
  10. R

    shower fan

    thank you once again.
  11. R

    shower fan

    please can you tell me if 1mm 3core cable plus earth is suitable for a shower fan thanks :?: :?:
  12. R

    Elctrical safety inspection

    Thank You very much for your speedy responce very helpful what a fab site. :D :D
  13. R

    Elctrical safety inspection

    can anbody help please,I have a property which i rent, it has just had a safety inspection which a few items where picked up. one being no local isolation switch for shower fan, code 2. this is on the ground floor of the property in a room with a half glazed door letting in natural light is this...
Back
Top