Search results

think 5 cores at junction box, might need a long length cat 5 to extend it from downstairs

I want to test the continuity of cable from boiler downstairs to the cupboard upstairs, what is the best way to do that?

I was wondering if someone could guide me through adding the selfmon to HA. I have the selfmon VKP on phone, is it one of these I need to configure?

I have a house of myson trv, tried to swop with a Drayton but thread seems different, is that right, wanted to fit some Tado ones but now concerned they won't fit?

This consumer unit is metal in a waterproof outside unit next to main meter. 25mm tails are used and cable is on a 15m run protected by an rcd. This consumer unit is used for outside lighting and jacuzzi.

Yes wrong forum. Cable size and rcd all right for the 7kw load with EV charger, just I would have expected the cable to be fixed to the consumer unit in some way. maybe regulations don't specify this?

Not checked that, will do tomorrow but nothing at consumer unit, just passes through a hole cleated to wall but no gland.

I had an electrician run some armoured cable from an outside metal consumer unit to an eV charger. At the consumer unit the cable just enters through a hole, no gland or fixing. Is this acceptable?

Cheers

You know of any?

Ok think i found the contact sensor DO8M, Wireless Magnetic Door/Window Contact, had no battery so replaced,

I have the Honeywell Galaxy 2-44 ADT alarm system in house I bought, under no contract with ADT. Firstly what door sensors are they as one appears to be broken on mine and giving tamper fault. The other question, the two remaining errors are the number to dial and ARC comms fail, I am assuming...

yes clear head tomorrow start all over

i had lead on a usb extension, not sure that would be an issue though? Will put wintex on laptop tomorrow try without an extension to the usb.

tried com 1 and com 2

1. no udl passcode or it doesn't match CHECKED 2. comport you have connected to is not programed as not used. CHECKED 3. panel details don't match that selected in wintex. CHECKED 4.com selected is not the correct comport. CHECKED

connection to the panel could not be established

I removed smartcom, but it lost all programming so need to connect again with wintex.

I am trying to connect wintex via PC com, i have com 1 set to nothing fitted, connecting my USB cable to com 1 on board, set PC com to correct port, in my case com 4, but it just refuses to connect. I have reset system as removed battery and the IP com unit, now need to send the data back to set...

OK thanks, ill give them a shout