Search results

Hi all Need to move a path to the edge of my land. All permissions have been sought and granted. I was wondering how do I go about building this tarmac path? How much would a builder charge to lay a tarmac path 3ft wide by 44ft long? Would laying a concrete path be better? pros and...

Hi all, I am going to tile my bathroom its about 2m square, I was going to use the bal flexable adhesive and grout and then 12mm WBP ply. But Topps tiles reccomend I use 6mm or 12mm tile backerboard. Is this better or worse than ply? For the job: I was going put adhesive down first...

Hi all, I am putting this wall mural on an end wall in a bedroom/home office. What colour do you suggest for the remaining walls? The carpet is beige and all doors, windowsills are gloss white. Regards.

Hi all Got a major problem, when i put my ear to the side of the house i can hear trickling water from inside the wall cavity. There are no pipes in the wall . The house stop cock is in the garage floor when it is turned off I can still here the water. I have listened at the stop cock and...

Hi all, Just had a new pump, hot cylinder, cold loft tank, programmer and tank, room stats fitted. I went up in the loft and the expansion tank (the small one) is full of very hot water!!!! Is there a problem and do I need to call back the heating engineers? Any and all help much...

Hi Have a torbeck valve in my toilet cistern. Problem is that the cistern is always filling and overflowing into the toilet bowl. I have cleaned the valve and everything, but the water level continues to rise above the float and the fill level mark until it gets to the overflow. I have...

Been advised on a previous post to replace old hot water cylinder with an unvented one. Pressure is good in my area. Any suggestions on what I should be looking for? Make, model, type etc. I live in a 3 bed, 2 bathroom house with 8 rads. Any suggestions on tank size? Typical...

Converting system to Y-Plan, which pump and three way valve make and model would you suggest? The programmer and room thermostat I have selected are Honeywell ST9400C and CM927 respectively. The house consists of 8 rads, 2 baths, 3 toilets and 1 power shower running off a baxi back boiler...

Hi all First post so be gentle!!!! Anyway here goes. Current components: Programmer - AMF Venner dial type separate hot water/heating controls Hot water cylinder stat - Danfoss Ravi Plunger style Room Stat - Honeywell T6360B Gravity fed system with Baxi back boiler. I want...