Search results

Hello, I'm hoping someone's encountered this before and might be able to help. I'm finally getting 'round to fitting a couple of shower trays. It comes as a PROWARM 30mm end drain shower tray. It looks identical to an AQUADRY kit I've also seen. It's a 30mm pre-moulded backerboard with a drain...

Hello all.. I'm planning to replace my combi soon and am wondering which of the Vaillants to go for - the ECOTEC plus 825 or 832? I don't fully understand the differences (efficiency, power, capability etc.) but I have a two bedroom / one bathroom flat (draughty) with double panel radiators...

Hello all. I have a quick one.. I've read around a lot, but have no definitive answer yet. I'm looking to position a shaver socket by a countertop basin which will primarily be used for an electric toothbrush. For this reason, I don't want it too high so the charger cable can simply remain...

I hope someone may be able to help please.. I'm not sure I've only just noticed this, but of recent our Worcesester (non condensing) boiler does a short fan cycle each time any water is used - either hot or cold. I'm pretty sure that it hasn't done that before? The fan cycles when the...

Hi.. I just received a set of Grohe shower taps with an 'S' union wall escutcheon kit, and the 1/2 male end has linear scores all the way along the thread.. Am I right in thinking that this for use with threading sealants? I'm currently using Loctite 55, and not hemp/paste, and the...

Problem sorted..

I'm having great difficulty removing (without forcing) a thermostat / lamp casing from a Bosch fridge. There's one screw behing a little grey plastic cap (easy), but the lamp assembly seems to be holding tight to the fridge side? So the housing is loose, but attached to the fridge with what...

I have a 10 yo Bosch larder fridge (single door) which suddenly stoppped cooling. I suspected a thermostat problem & switched the dial to "off", waited, and switched it back on. It now works when set to full (5). If I reduce the temp setting, it stops agian and I have to switch it off for a...

:cry: I've had my enamel bath for years and today I decided to use some descaler to remove some tired 'run marks'. I told myself I'd n e v e r do it, but today I did. Now, alas, the lower half of the bath has significantly lost its "glassy" finish... Is there any product I can use to...

Hello all Some help please - I've recently had this boiler fitted to my holiday home in France. It's in an en-suite next to a bedroom. As the boiler has a 50 litre built in hot water cylinder, it ticks over during the night to maintain water temperature, which is a little annoying while...