Where can i get the nut to fit this P&T valve. I've looked through the usual screwfix/tool station catalog but no joy.
15 mm connection for P&T valve
- Thread starter langtounboy
- Start date
Where can i get the nut to fit this P&T valve. I've looked through the usual screwfix/tool station catalog but no joy.1/2 inch male iron, job done.
many thanks 
Screwfix Part No 69358
- Joined
- 10 Oct 2011
- Messages
- 16,396
- Reaction score
- 4,043
- Country
Where can i get the nut to fit this P&T valve. I've looked through the usual screwfix/tool station catalog but no joy.
It gets worse..
P
Phill Peck
Are you installing an unvented cylinder and don't know what a 1/2" thread is 
Feck me. This will be a quality install I am sure 
Before there's anymore p1ss taking I'm not installing it, I know what a 1/2 in thread is, I was looking for the 1/2 inch nut rather than a 1/2" to 15mm converter
I thought this was a forum for advice not for sanctimonious halfwits
I thought this was a forum for advice not for sanctimonious halfwits
- Joined
- 10 Oct 2011
- Messages
- 16,396
- Reaction score
- 4,043
- Country
.....and what exactly are you gonna do with the "nut"?
why not get your installer to decide what to use?
and only a halfwit would install his own unvented cylinder.......
and only a halfwit would install his own unvented cylinder.......
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
