Hello
I have searched previous posts relating to 2 port valves trying to find the solution to my problem....
My 2 port valve paddle was loose. the reason I found this out was when I switched the boiler on it would stay on full blast all the time and I tried to find the solution. I found the paddle to be loose and came to the conclusion that the valve was stuck open and gave the boiler the signal to keep going....
I have replaced the motor to my 2 port valve as the other valve seemed to be faulty. This did not cure my problem. The new valve motor's paddle is loose too. I think the reason is that the valve is stuck and the motor cannot move it. Is this right?
The reason I am on here rather than simply taking it off and trying to free it is that that valve is directly behind the cylinder and is extremely difficult to reach and remove.
If any one can help I would be extremely grateful.
James
I have searched previous posts relating to 2 port valves trying to find the solution to my problem....
My 2 port valve paddle was loose. the reason I found this out was when I switched the boiler on it would stay on full blast all the time and I tried to find the solution. I found the paddle to be loose and came to the conclusion that the valve was stuck open and gave the boiler the signal to keep going....
I have replaced the motor to my 2 port valve as the other valve seemed to be faulty. This did not cure my problem. The new valve motor's paddle is loose too. I think the reason is that the valve is stuck and the motor cannot move it. Is this right?
The reason I am on here rather than simply taking it off and trying to free it is that that valve is directly behind the cylinder and is extremely difficult to reach and remove.
If any one can help I would be extremely grateful.
James