3/4" Shower Valve from 1/2" Pipework

gdickin2 · 19 Mar 2009

I am going to buy a Crosswater thermostatic shower valve mixer to replace an old valve in my ensuite.
The technical data I have on the valve states it has 3/4" BSP connections for input and output. However my pipework feeding the valve is 1/2".
I am assuming I can just plumb it using 1/2"-3/4" reducers (or expanders in this case)?
Will it have an adverse effect on the operating pressure of the valve - which incidentally says it's suitable for low and high pressure systems?

Cheers

littleleaks · 19 Mar 2009

nope thats fine what your going to do

gdickin2 · 19 Mar 2009

littleleaks said:
nope thats fine what your going to do

Thanks very much littleleaks.

diynot

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.

Are you a trade or supplier? You can create your listing free at DIYnot Local

3/4" Shower Valve from 1/2" Pipework

gdickin2

littleleaks

gdickin2

DIYnot Local

Similar threads