Hi everyone.
I’m am in the process of wiring in an alarm system.
Accenta g4 alarm panel with a reson8 bell box.
Unfortunately nothings working, ie no red LED and no green LED.
The wiring connections are:-
Strobe- on panel to stb- on bell box
T on panel to rtn- on bell box
A on panel to hold off- on bell box
D on panel to hold off+ on bell box
B on panel to trig on bell box
I am trying to work out exactly how the connections work.
Am I correct in the following.
Trigger (B), no alarm 12V, alarm condition 0v
Strobe, no alarm 12V, alarm condition 0v
A and D 12 volt supply, should always be at 12V
T, on the Reson8 this is lust a loop, from hold off – to rtn. Thus it returns 0V, from A, back to the control panel T.
Thanks, in advance for your replies.
Pete
I’m am in the process of wiring in an alarm system.
Accenta g4 alarm panel with a reson8 bell box.
Unfortunately nothings working, ie no red LED and no green LED.
The wiring connections are:-
Strobe- on panel to stb- on bell box
T on panel to rtn- on bell box
A on panel to hold off- on bell box
D on panel to hold off+ on bell box
B on panel to trig on bell box
I am trying to work out exactly how the connections work.
Am I correct in the following.
Trigger (B), no alarm 12V, alarm condition 0v
Strobe, no alarm 12V, alarm condition 0v
A and D 12 volt supply, should always be at 12V
T, on the Reson8 this is lust a loop, from hold off – to rtn. Thus it returns 0V, from A, back to the control panel T.
Thanks, in advance for your replies.
Pete