Any help on getting power to boiler please ??

[Lucie6]

Yesterday I bled a radiator and then my ideal icos he12 boiler has knocked off.

I checked the pressure and it was below 1, so I have used the filling loop and raised the pressure back up to about 1.7, but I have no power to my boiler still. Looked at the manual on how to light pilot light but no joy.
changed fuse to.

Has some sort of switch tripped ?
Just can't seem to find out how to get power to my boiler?

Any help, before I have to ring a plumber.

Thanks [/b]

 

[mcmoby69]

anything showing on the LED display?

any obvious signs of water coming from the boiler casing or anywhere in the house? things you should look for before calling a plumber (water leaks in the house) or boiler engineer (water coming from the boiler)

check any circuit breakers and if you have a power cut, any lights working? did you check the new fuse was ok?

 

[Johnmelad]

How do you know that there is no power at the boiler?

 

[ljrgas]

run a extension lead

what boiler is it?

 

[Lucie6]

Thanks for replying.

There is no power because there are no lights on, on the boiler ??

 

[algas]

Looks like the circuit board is dead

 

[Lucie6]

Would this have happened then from bleeding a radiator ?

 

[algas]

Yes its possible if you let all the pressure out of the system the pump could run dry & that could knock out the board

 

[Agile]

If you dont know how to bleed rads properly then DONT bleed rads!

 

[Lucie6]

Hi algas thanks for the reply. It dropped to 1 bar it did once bled.