Baxi solo 2, just keeps sparking even though the pilot is on

[creasote]

I have cleaned port hole, cleaned ignitor, there is a good spark and it is in the flame, a good 20mbr pressure, but ignitor just keeps sparking.. click..click..click... fault finding instructions say it is either the lead which would mean that there would be no spark? or it is the pcb.
do i go out and buy the pcb? by the way I am gas registered!
it can be the gas valve? or there would be no gas?

 

[Meldrew's mate]

If the pilot is lit and it keeps sparking then the pcb has a fault - and requires changing.

 

[Eeejit]

you`ll find same question on page2
sent in by w.a.l.o.Baloney

 

[namsag]

As the board on these are 130 quid i would try the lead and electrode first after being absolutely certain pilot is spotless and correct size

 

[superdupergasman]

As Namsag says, strip and clean out the pilot as these are bad for clogging up.

Then an electrode and lead,

Last resort PCB.

 

[baxpoti]

Check the lead is very tight onto the electrode.