Pls can you tell me how “bench dog clamps” work? Those I’ve looked at seem to consist of a tube 19 or 20 mm with an arm at right angles to that and an overcentre clamp on the end of the arm. I don’t understand why when you operate the clamp the tube doesn’t just slide up out of the hole in the bench. Cheers, Terry
Bench dog clamps
- Thread starter elcaro
- Start date
Sponsored Links
Rsgaz thank you. I wondered if that was how it worked but wanted to check. I want something to hold down a straight edge guide (eg a bit of 3 ply) on top of the work but still be low enough for the motor of a circular saw to pass over it.
Thanks from Terry
Thanks from Terry
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
