I have a Bosch 4303 built in (with the cabinet panels) d/w installed 2002. Has been running brilliantly all this time. A month ago, wife describes a 'funny noise' (like a pop or a bang), and suddenly it won't fill when she turns it on. Put water in it, and it runs through the cycle fine, but the fills in between cycle changes are ridiculously slow - drip, drip, trickle.
So I replace the float switch, the inlet valve, and the control panel. Checked the hose, not kinked, nothing in the screen. Cleaned out the screen at the bottom plus anything else I could reach, nothing was especially dirty.
I'm up $200 in parts and the damn thing still trickles on fill. Any other ideas? She doesn't want to get rid of it because it matches the cabinetry, I'm ready to give it a peaceful death - or else spend the rest of its life hand filling it.
What other possible options would cause the inflow to be so slow? The line also feeds the sink and the flow there is fine. Help!
So I replace the float switch, the inlet valve, and the control panel. Checked the hose, not kinked, nothing in the screen. Cleaned out the screen at the bottom plus anything else I could reach, nothing was especially dirty.
I'm up $200 in parts and the damn thing still trickles on fill. Any other ideas? She doesn't want to get rid of it because it matches the cabinetry, I'm ready to give it a peaceful death - or else spend the rest of its life hand filling it.
What other possible options would cause the inflow to be so slow? The line also feeds the sink and the flow there is fine. Help!