Hi my Bosch classixx slimline dishwasher has stopped heating the water & it takes twice as long to run& its not drying the stuff at the end,its around 5 years old?
cheers
nige.
cheers
nige.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Bosch Classixx Dishwasher Problem.
- Thread starter themilkybarkid
- Start date
you have 1 of 3 possibilities
could be something elese but is highly unlikely
1) faulty heating element
2) faulty thermostat
3) faulty PCB
PCB is likely to show burnt tracks if faulty
element can be tested with a meter tester , and can be accessed via removal of a side panel
thermostat is on the element housing looks like this
http://www.casaparts.co.uk/products/id-25080927
element is at the bottom of the picture , stat goes in the hole in the middle an looks like this
http://www.casaparts.co.uk/products/id-25080903
could be something elese but is highly unlikely
1) faulty heating element
2) faulty thermostat
3) faulty PCB
PCB is likely to show burnt tracks if faulty
element can be tested with a meter tester , and can be accessed via removal of a side panel
thermostat is on the element housing looks like this
http://www.casaparts.co.uk/products/id-25080927
element is at the bottom of the picture , stat goes in the hole in the middle an looks like this
http://www.casaparts.co.uk/products/id-25080903
Hi cool cheers do you know how to get to the pcb?
undo the t20 screws down the sides and top of the inside of the door
lower front panel will fall out , catch it or you might scratch it !!
the facia panel then needs to be gently eased out a little ( many wires )
pcb now exposed
, will have several multi pin connectors , take a photo of where all the wires go before removing
the plastic box contains the circuit board. have a look in here for any tiny black smokey bits which may expose evidence of a flash.
lower front panel will fall out , catch it or you might scratch it !!
the facia panel then needs to be gently eased out a little ( many wires )
pcb now exposed
, will have several multi pin connectors , take a photo of where all the wires go before removing
the plastic box contains the circuit board. have a look in here for any tiny black smokey bits which may expose evidence of a flash.
Cheers thats my job for the night then 
Hi yeh looks like the pcb can you buy that bit the number for the dishwasher is SRS43A02GB/08
cheers
nige.
cheers
nige.
Hi it looks like it was just a small hole so i put a bit of solder back in there & it seens to be working fine now so hopefully its sorted,thanks for all your help.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local