Afternoon all, hope everyone has had a great Christmas! I certainly was until the 3rd load in our DW came to a stop half way through.
Ser no. SGS43EO2GB/35
Any help would be most appreciated
Here goes: the DW switches on as normal and can be reset as normal. It pumps out properly, the wash pump runs properly.
The anti flood device is working as it should. The problem is after running for a few minutes it just stops, as if the door had been opened, it then takes a few minutes before it can be started again.
My next avenue of investigation is the PCB, could it be a dry joint?
Thanking you all in advance.
Graham
Ser no. SGS43EO2GB/35
Any help would be most appreciated
Here goes: the DW switches on as normal and can be reset as normal. It pumps out properly, the wash pump runs properly.
The anti flood device is working as it should. The problem is after running for a few minutes it just stops, as if the door had been opened, it then takes a few minutes before it can be started again.
My next avenue of investigation is the PCB, could it be a dry joint?
Thanking you all in advance.
Graham
