Bosch integral dishwasher won't start properly

[g3rfh]

I have a Bosch integral dishwasher about 2 years old. The tap indicator comes on but I have checked the water supply which is OK. All filters are clean. When holding the Inlet filter housing (aqua stop inside?) I can feel the water coming on and going off at about 2 second intervals. Also the housing gets a bit warm. The pump pumps out ok after pressing reset buttons. The other problem is that the floor was tiled around the unit after it was fitted, meaning that to get it right out will require some tiles to be removed! Any suggestions please?
Ken (Blackpool)

 

[g3rfh]

Problem solved: Instead of destroying tiles, which cannot be replaced, I have dismantled (broken up!) the dishwasher, which can be replaced! Was going to cost a lot to repair after the fault was found anyway, so might as well get a new one and start all over. It was a so called 'free offer' when the kitchen was installed, so no sweat.
Cheers Ken.