- Joined
- 10 Apr 2017
- Messages
- 17
- Reaction score
- 0
- Country
Hi - another grand cockup by me that I just want some advice on...
I needed to use a bit of woodfiller on my floorboards last week and when sanding it down I obviously rubbed off the sheen. So I shopped around for a suitable finish to touch it up with, and I opted for Osmo Polyx Hard Wax Oil (Clear Satin, which supposedly doesn't change the colour of the wood). https://www.osmouk.com/sitechapter.cfm?chapter=82&page=247
Attempt one worked very well and the resulting sheen was a perfect match. But then I realised I'd used the wrong colour woodfiller. So I gouged that out, refilled, and sanded once again.
Here's where the problem occurred. On the second sanding I went deeper and noticed a 'ripple' effect around the deepest spots. This, I'm now presuming, was me sanding through a laquer film that I had previously left in tact. When I dabbed these spots of wood with water they darkened noticably, but the liquid evaporated after a few hours so I thought it was no biggy.
Darkening also occurred when I re-applied the Osmo, but I hoped it'd lighten while drying as it had before (Osmo product info says it's microporous, so I figured the liquid can escape). No such luck. It's been five days now and as you can see it's still very dark in sunlight. I know these oils take longer to cure, but my gut is telling me I've messed up again.
Can anyone give some advice? I know I'm an idiot, you don't need to point that out!!
I needed to use a bit of woodfiller on my floorboards last week and when sanding it down I obviously rubbed off the sheen. So I shopped around for a suitable finish to touch it up with, and I opted for Osmo Polyx Hard Wax Oil (Clear Satin, which supposedly doesn't change the colour of the wood). https://www.osmouk.com/sitechapter.cfm?chapter=82&page=247
Attempt one worked very well and the resulting sheen was a perfect match. But then I realised I'd used the wrong colour woodfiller. So I gouged that out, refilled, and sanded once again.
Here's where the problem occurred. On the second sanding I went deeper and noticed a 'ripple' effect around the deepest spots. This, I'm now presuming, was me sanding through a laquer film that I had previously left in tact. When I dabbed these spots of wood with water they darkened noticably, but the liquid evaporated after a few hours so I thought it was no biggy.
Darkening also occurred when I re-applied the Osmo, but I hoped it'd lighten while drying as it had before (Osmo product info says it's microporous, so I figured the liquid can escape). No such luck. It's been five days now and as you can see it's still very dark in sunlight. I know these oils take longer to cure, but my gut is telling me I've messed up again.
Can anyone give some advice? I know I'm an idiot, you don't need to point that out!!
Attachments
Last edited: