I want to box it in, in a way that looks tidy. It measures 7.5 cm to the top of the pipe, from the wall. I thought I would need to batten and MDF it...
I did consider extending the ceiling by boxing the whole lot. The ceiling would be extended at the same level and then straight up. I could then fit the coving to this section, as you are suggesting.
However, to the right the pipe goes into the slope of the stairs. It pierces through the bottom of this section. That would still look odd.
All things considered, I was planning to create a box all the way along (horizontal and vertical) the pipe and leave the coving in place.
This feels like an eyesore too. Not sure how well I have explained this.
You could try boxing to the ceiling and re fixing a new bit of coving.
Just a side note what is it carrying? I guess water, but any gas pipes in boxing should be ventilated at both ends.
You could try boxing to the ceiling and re fixing a new bit of coving.
Just a side note what is it carrying? I guess water, but any gas pipes in boxing should be ventilated at both ends.
It’s a gas pipe. It comes up in a cupboard where it’s open and then enters the boiler cupboard upstairs where it is open too. I assume that means that I can box it up here?
I like the coving idea and boxing up to the top. I just have that section in the side that will still look odd.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local