Hi guys,
Hope you are all keeping well.
My printer roll reached it's end yesterday, and the tight wrapped lables were coming unstuck.
It caught on bits of roller/guide etc, and left bits of sticky label on the bed under the roller.
'Dead easy' thought I. I'll just whip the roller out, clean the plate and roller, and re insert said roller.
I've removed all the screws that I see, but the top still dosn't budge.
I removed screws underneath, but that only goes to the pcb's etc.
I'm assuming that -like phones/remotes etc - the case now 'clips' on/off.
Am I assuming right ?
Does anyone know where to start ?
(another Brother [different] printer quest next)
cheers
Hope you are all keeping well.
My printer roll reached it's end yesterday, and the tight wrapped lables were coming unstuck.
It caught on bits of roller/guide etc, and left bits of sticky label on the bed under the roller.
'Dead easy' thought I. I'll just whip the roller out, clean the plate and roller, and re insert said roller.
I've removed all the screws that I see, but the top still dosn't budge.
I removed screws underneath, but that only goes to the pcb's etc.
I'm assuming that -like phones/remotes etc - the case now 'clips' on/off.
Am I assuming right ?
Does anyone know where to start ?
(another Brother [different] printer quest next)
cheers