Can anyone suggest some 'clips' for holding boards in place?

[Redrama]

We need to buy a number of heavy duty clips to hold large mdf boards in place to hide wiring behind a number of editing stations.

The wiring will need frequent access so the boards will need to be removed and reattached often.
Can anyone suggest anything - any links of where to buy from?

Any help much appreciated!

 

[OwainDIYer]

The sort of thing used for attaching plinths below kitchen units

http://www.tandsarchitectural.co.uk/products.asp?categoryID=5735

 

[Redrama]

OwainDIYer - that's exactly what I was hoping for. Thanks a lot for your time mate!

 

[foxhole]

You need something much stronger , mdf is heavy in large sheets, KeKU clips or similar.
http://www.fix8.co.uk/products/Hardware/Hafele+Products/KeKu+Clips?gclid=CMS4m_nDp6wCFUEb4QodbXbPZA

 

[TicklyT]

Fix a couple of pieces of extruded aluminium channel to the top and bottom of the aperature for the panel.

Trim the panel to the size of the remaining aperature plus the depth of one channel.

Fit a packing piece half the depth of the channel into the lower channel.

Insert the panel by sliding the top edge upwards into the top chanel, and then dropping the lower edge onto the packing piece in the bottom channel.

No springs to fail
No clips to fall apart.
No screws to get mashed up or lost.
Everything held in place by by gravity, and that's unlikely to fail - in fact there's so much of it about, most can even afford to leave it switched on at the weekends when they aren't there!