Hi everyone - I'm now quite stumped with this so any help would be hugely appreciated.
Our Candy CDI 1012 was playing up last week so I had a play with it and diagnosed the safety switch and PCB. While playing around with it (tilting it, spilling water while removing parts etc) a new fault came into the mix; that being the drain pump ran continuously while the power switch was on. I thought no more of it until I fitted the new PCB and safety switch and found that the continuous running of the drain pump is still an issue.
I've spent two days trying out different things with this but I've now hit a brick wall. I held down the program selector button to reset the washer and it displayed lights 1,2 & 3 together before then changing to light 3 only. It then went back to flashing all 4 lights which is the program select mode. Do the sequence of lights I mentioned indicate a fault code and, if so, what is it?
Thanks in advance guys.
FH
Our Candy CDI 1012 was playing up last week so I had a play with it and diagnosed the safety switch and PCB. While playing around with it (tilting it, spilling water while removing parts etc) a new fault came into the mix; that being the drain pump ran continuously while the power switch was on. I thought no more of it until I fitted the new PCB and safety switch and found that the continuous running of the drain pump is still an issue.
I've spent two days trying out different things with this but I've now hit a brick wall. I held down the program selector button to reset the washer and it displayed lights 1,2 & 3 together before then changing to light 3 only. It then went back to flashing all 4 lights which is the program select mode. Do the sequence of lights I mentioned indicate a fault code and, if so, what is it?
Thanks in advance guys.
FH